Liu Yangbiao, Zojer Egbert, Zharnikov Michael
Angewandte Physikalische Chemie, Universität Heidelberg, Im Neuenheimer Feld 253, D-69120 Heidelberg, Germany.
Institute of Solid State Physics, NAWI Graz, Graz University of Technology, Petersgasse 16, 8010 Graz, Austria.
ACS Appl Mater Interfaces. 2022 Nov 23;14(46):52499-52507. doi: 10.1021/acsami.2c15308. Epub 2022 Nov 10.
Self-assembled monolayers (SAMs) of ferrocene-substituted thiofluorene on Au(111) exhibit two distinct conductance states (CSs) in two-terminal junctions featuring a sharp tip of eutectic GaIn as the top electrode. The occurrence of these states and the resulting effective rectification by the SAM depend on the way the bias voltage is swept; when the junction is only negatively biased, the original, high CS is preserved, whereas the junction is switched to a low CS when applying only positive biases. This results in an exceptionally high effective rectification ratio (RR) of ∼2100 already at voltages as low as 0.1 V. In contrast, when sweeping the junction alternatingly to the maximum positive and negative bias voltages (as usually performed in the literature), fully symmetric - curves are observed. That is, for the present SAM, rectification disappears, and the effective RR is ≈1. It is noteworthy that whether the junction in these symmetric sweeps is in the high or low CS depends on the polarity of the first sweep. We attribute the occurrence of the two CSs to a (quasi) non-reversible oxidation of the ferrocenes in combination with structural changes in the monolayer geometry. The observed sweeping dependence of the conductivity switching is an additional parameter that needs to be considered when interpreting experimental - curves, especially when dealing with redox-active systems.
在以共晶镓铟的尖锐尖端作为顶部电极的两终端结中,二茂铁取代的硫芴在金(111)上的自组装单分子层(SAMs)呈现出两种不同的电导状态(CSs)。这些状态的出现以及SAM产生的有效整流取决于偏置电压的扫描方式;当结仅被负偏置时,原始的高电导状态得以保留,而仅施加正偏置时,结会切换到低电导状态。这导致在低至0.1 V的电压下就已经有高达约2100的异常高的有效整流比(RR)。相比之下,当交替将结扫描到最大正偏置电压和负偏置电压时(如文献中通常所做的那样),会观察到完全对称的曲线。也就是说,对于当前的SAM,整流消失,有效RR约为1。值得注意的是,在这些对称扫描中结处于高电导状态还是低电导状态取决于第一次扫描的极性。我们将这两种电导状态的出现归因于二茂铁的(准)不可逆氧化以及单分子层几何结构的变化。观察到的电导率切换对扫描的依赖性是在解释实验曲线时需要考虑的一个额外参数,特别是在处理氧化还原活性系统时。