Rajewska Paulina, Janiszewska Jolanta, Rajewski Jakub
Łukasiewicz Research Network-Institute for Sustainable Technologies, ul. K. Pułaskiego 6/10, 26-600 Radom, Poland.
Faculty of Chemistry, Warsaw University of Technology, Noakowskiego 3, 00-664 Warszawa, Poland.
Membranes (Basel). 2023 Jan 3;13(1):59. doi: 10.3390/membranes13010059.
The article analyzes integrated ultrafiltration (UF) and nanofiltration (NF) processes for potato processing wastewater treatment for the purpose of which a laboratory filtration system for flat sheet membranes with the effective surface area of 1.4 × 10 m (UF: polysulfone, cut-off: 10,000 Da; NF: polypiperazine amide, cut-off: 150-300 Da) was used. As part of the study, the effect of the transmembrane pressure of UF (0.2 MPa and 0.4 MPa) and NF (1.0 MPa and 1.8 MPa) on the permeate flux and rejection coefficient was investigated and the impact of sewage preparation methods on the degree of pollution reduction was determined. Moreover, a method for a fouling layer removal from the UF membranes is also proposed. The results of the analyses conducted by the authors show that the pretreatment stage offers additional advantages to TSS and turbidity removal. In both cases (0.2 and 0.4 MPa), UF used after the pretreatment process resulted in a 97-99% reduction in these impurities. The analysis of the determined rejection coefficients shows that the use of NaOH and HO for the regeneration of the UF membrane has a positive effect on filtration efficiency. Regarding NF, the rejection coefficients for most tested parameters were higher for the 1.8 MPa process compared to 1.0 MPa, and approximately 80% of water was recovered.
本文分析了用于马铃薯加工废水处理的集成超滤(UF)和纳滤(NF)工艺,为此使用了有效表面积为1.4×10平方米的平板膜实验室过滤系统(超滤:聚砜,截留分子量:10,000道尔顿;纳滤:聚哌嗪酰胺,截留分子量:150 - 300道尔顿)。作为研究的一部分,研究了超滤(0.2兆帕和0.4兆帕)和纳滤(1.0兆帕和1.8兆帕)的跨膜压力对渗透通量和截留系数的影响,并确定了污水预处理方法对污染降低程度的影响。此外,还提出了一种从超滤膜上去除污垢层的方法。作者进行的分析结果表明,预处理阶段在去除总悬浮固体(TSS)和浊度方面具有额外优势。在两种情况下(0.2兆帕和0.4兆帕),预处理后使用超滤可使这些杂质减少97 - 99%。对所确定的截留系数的分析表明,使用氢氧化钠和过氧化氢对超滤膜进行再生对过滤效率有积极影响。对于纳滤,与1.0兆帕的工艺相比,1.8兆帕工艺下大多数测试参数的截留系数更高,并且回收了约80%的水。