Opt Express. 2023 Feb 27;31(5):7774-7788. doi: 10.1364/OE.480346.
Highly-time-resolved and precise tracking of position, velocity, and acceleration is urgently required when highly dynamic legged robots are walking, trotting, and jumping. Frequency-modulated continuous-wave (FMCW) laser ranging is able to provide precise measurement in short distance. However, FMCW light detection and ranging (LiDAR) suffers from a low acquisition rate and poor linearity of laser frequency modulation in wide bandwidth. A sub-millisecond-scale acquisition rate and nonlinearity correction in the wide frequency modulation bandwidth have not been reported in previous studies. This study presents the synchronous nonlinearity correction for a highly-time-resolved FMCW LiDAR. The acquisition rate of 20 kHz is obtained by synchronizing the measurement signal and the modulation signal of laser injection current with a symmetrical triangular waveform. The linearization of laser frequency modulation is conducted by resampling of 1000 intervals interpolated in every up-sweep and down-sweep of 25 µs, while measurement signal is stretched or compressed in every period of 50 µs. The acquisition rate is demonstrated to be equal to the repetition frequency of laser injection current for the first time to the best of authors' knowledge. This LiDAR is successfully used to track the foot trajectory of a jumping single-leg robot. The high velocity up to 7.15 m/s and high acceleration of 365 m/s are measured during the up-jumping phase, while heavy shock takes place with high acceleration of 302 m/s as the foot end strikes the ground. The measured foot acceleration of over 300 m/s, which is more than 30 times gravity acceleration, is reported on a jumping single-leg robot for the first time.
当高速动态腿式机器人行走、小跑和跳跃时,迫切需要对位置、速度和加速度进行高时间分辨率和精确跟踪。调频连续波(FMCW)激光测距能够在短距离内提供精确测量。然而,FMCW 光探测和测距(LiDAR)在宽带宽下存在激光频率调制的低采集率和较差的线性度。在以前的研究中,没有报道过亚毫秒级的宽频带调制非线性校正。本研究提出了一种高时间分辨率 FMCW LiDAR 的同步非线性校正方法。通过将测量信号和激光注入电流的调制信号与对称三角波形同步,获得了 20 kHz 的采集率。通过对每个 25 μs 的上扫和下扫中的 1000 个插值间隔进行重采样,实现了激光频率调制的线性化,同时在每个 50 μs 的周期内拉伸或压缩测量信号。据作者所知,这是首次实现激光注入电流的重复频率与采集率相等。该 LiDAR 成功用于跟踪跳跃单腿机器人的脚部轨迹。在向上跳跃阶段,测量到高达 7.15 m/s 的高速度和 365 m/s 的高加速度,而当脚部末端撞击地面时,会发生高达 302 m/s 的剧烈冲击。在跳跃单腿机器人上首次测量到超过 300 m/s 的脚部加速度,超过重力加速度的 30 倍。