Abbas Mahmoud I, El-Khatib Ahmed M, Elsafi Mohamed, El-Shimy Sarah N, Dib Mirvat F, Abdellatif Hala M, Baharoon Raqwana, Gouda Mona M
Physics Department, Faculty of Science, Alexandria University, Alexandria 21511, Egypt.
Clinical Oncology and Nuclear Medicine Department, Faculty of Medicine, Alexandria University, Alexandria 21511, Egypt.
Materials (Basel). 2023 Mar 2;16(5):2056. doi: 10.3390/ma16052056.
Due to the present industrial world, the risk of radioactivity is notably increasing. Thus, an appropriate shielding material needs to be designed to protect humans and the environment against radiation. In view of this, the present study aims to design new composites of the main matrix of bentonite-gypsum with a low-cost, abundant, and natural matrix. This main matrix was intercalated in various amounts with micro- and nanosized particles of bismuth oxide (BiO) as the filler. Energy dispersive X-ray analysis (EDX) recognized the chemical composition of the prepared specimen. The morphology of the bentonite-gypsum specimen was tested using scanning electron microscopy (SEM). The SEM images showed the uniformity and porosity of a cross-section of samples. The NaI (Tl) scintillation detector was used with four radioactive sources (Am, Cs, Ba, and Co) of various photon energies. Genie 2000 software was used to determine the area under the peak of the energy spectrum observed in the presence and absence of each specimen. Then, the linear and mass attenuation coefficients were obtained. After comparing the experimental results of the mass attenuation coefficient with the theoretical values from XCOM software, it was found that the experimental results were valid. The radiation shielding parameters were computed, including the mass attenuation coefficients (MAC), half-value layer (HVL), tenth-value layer (TVL), and mean free path (MFP), which are dependent on the linear attenuation coefficient. In addition, the effective atomic number and buildup factors were calculated. The results of all of these parameters provided the same conclusion, which confirms the improvement of the properties of γ-ray shielding materials using a mixture of bentonite and gypsum as the main matrix, which is much better than using bentonite alone. Moreover, bentonite mixed with gypsum is a more economical means of production. Therefore, the investigated bentonite-gypsum materials have potential uses in applications such as gamma-ray shielding materials.
由于当前的工业世界,放射性风险显著增加。因此,需要设计一种合适的屏蔽材料来保护人类和环境免受辐射。鉴于此,本研究旨在设计以低成本、丰富且天然的膨润土 - 石膏为主基质的新型复合材料。该主基质与不同量的作为填料的氧化铋(BiO)微米和纳米颗粒进行了插层。能量色散X射线分析(EDX)确定了制备样品的化学成分。使用扫描电子显微镜(SEM)测试了膨润土 - 石膏样品的形态。SEM图像显示了样品横截面的均匀性和孔隙率。使用NaI(Tl)闪烁探测器和四种不同光子能量的放射性源(Am、Cs、Ba和Co)。使用Genie 2000软件确定在有和没有每个样品的情况下观察到的能谱峰值下的面积。然后,获得了线性和质量衰减系数。将质量衰减系数的实验结果与XCOM软件的理论值进行比较后,发现实验结果是有效的。计算了辐射屏蔽参数,包括质量衰减系数(MAC)、半价层(HVL)、十分之一价层(TVL)和平均自由程(MFP),这些参数取决于线性衰减系数。此外,还计算了有效原子序数和积累因子。所有这些参数的结果得出了相同的结论,即证实了以膨润土和石膏的混合物作为主基质可改善γ射线屏蔽材料的性能,这比单独使用膨润土要好得多。而且,膨润土与石膏混合是一种更经济的生产方式。因此,所研究的膨润土 - 石膏材料在诸如γ射线屏蔽材料等应用中具有潜在用途。