Isotherm and kinetic investigations of sawdust-based biochar modified by ammonia to remove methylene blue from water.

Chemical industry effluent may pose significant environmental risks to both human health and the economy if it is not properly managed. As a result, scientists and decision-makers are paying increasing attention to developing a sustainable, low-cost wastewater treatment technique. This work aims to investigate the adsorption of Methylene Blue (MB) dye present in water using biochar derived from sawdust modified by boiling in an ammonia solution (SDBA). The properties of SDBA were characterized by BET, SEM, XRD, BJH, FT-IR, DTA, EDX and TGA analyses. The presence of -OH and -NH groups in SDBA was confirmed by FTIR, which proved that the NHOH treatment of biochar successfully added nitrogen groups on its surface. The influence of pH (2 to 12), MB dye initial concentration (20 to 120 mg/L), adsorbent dosage (0.5 to 4.0 g/L) and contact time (0 to 180 min) on the adsorption process has been investigated. The adsorption of MB dye is more favorable at basic pH, with optimum adsorption at pH 8. Using a starting concentration of 20 mg/L of MB dye and a 4.0 g/L SDBA dose, the maximum percent clearance of MB dye was 99.94%. Experimental results were fitted to the Freundlich (FIM), Tempkin (TIM) and Langmuir (LIM) isotherm models (IMs). The FIM fitted the equilibrium data well, with a 643.74 mg/g Q. Various error function models were used to test the data obtained from IMs. According to Error Function results, experimental data showed that it fits better for LIM and FIM. Kinetic studies indicated that the MB dye adsorption procedure followed pseudo-second-order (PSOM) kinetics based on film diffusion (FDM), pseudo-first-order (PFOM) and intra-particle diffusion models (IPDM). MB dye sorption on the SDBA involved electrostatic interaction, surface participation, hydrogen bond and π-π interactions. The adsorption mechanism of MB dye by SDBA was proposed as physical adsorption via the electrostatic attraction process. SDBA is an effective adsorbent in removing MB dye from water. Six adsorption-desorption cycles of the MB dye were run through the regeneration of SDBA with only a minimal amount of adsorption capacity loss, demonstrating the reusability of manufactured SDBA.