Wearing individualized 3D printed oral stent to protect normal tissues in patients with nasopharyngeal carcinoma during radiotherapy.

PURPOSE

To demonstrate a new individualized 3D printed oral stent in radiotherapy of nasopharyngeal carcinoma (NPC) patients and carry out a comparative analysis combining with clinical case.

MATERIAL AND METHODS

Thirty NPC patients treated in our institution from September 2021 to October 2022 were prospectively enrolled. An individualized 3D printed oral stent was designed for each patient, and one set of computed tomography (CT) slices were obtained with /without wearing the oral stent, respectively. After delineation of target volumes and organs at risk (OARs) on the two CT slices, we finished two treatment plans by using the same target objectives, critical constraints and plan setup for each patient. Finally, the dose distribution and other dosimetric parameters of target volumes and OARs between the two plans were compared.

RESULTS

Tongue volume and tongue length outside of mouth was 10.4 ± 2.5 cm and 2.8 ± 0.6 cm, respectively, distance between dorsal surface of oral tongue and plate increased from 0.3 ± 0.3 cm to 2.2 ± 0.5 cm by wearing the oral stent. For the target volume, there was no significant difference. However, D of tongue, tongue tip and periglottis decreased significantly from 6352.6 ± 259.9 cGy to 5994.9 ± 478.9 cGy, 3499.8 ± 250.6 cGy to 3357.7 ± 158.0 cGy and 6345.5 ± 171.0 cGy to 6133.4 ± 263.3 cGy, respectively (p = 0.000); D of tongue, tongue tip and periglottis decreased significantly from 3714.7 ± 204.2 cGy to 3169.7 ± 200.9 cGy, 3060.8 ± 216.2 cGy to 2509.6 ± 196.7 cGy and 3853.3 ± 224.9 cGy to 3079.3 ± 222.0 cGy, respectively (p = 0.000).

CONCLUSION

The individualized 3D printed oral stent can reduce the dose of oral tissues and organs, so as to reduce the oral adverse reactions and improve the compliance of patients and the quality of their life. The technique can be used in radiotherapy of NPC patients.