Supajaruwong Siriboon, Porahong Sirawich, Wibowo Agung, Yu Yu-Sheng, Khan Mohd Jahir, Pongchaikul Pisut, Posoknistakul Pattaraporn, Laosiripojana Navadol, Wu Kevin C-W, Sakdaronnarong Chularat
Department of Chemical Engineering, Faculty of Engineering, Mahidol University, Nakhon Pathom, Thailand.
Department of Chemical Engineering, National Taiwan University, Taipei, Taiwan.
Sci Technol Adv Mater. 2023 Oct 17;24(1):2260298. doi: 10.1080/14686996.2023.2260298. eCollection 2023.
Carbon dots (CDs) are a new class of nanomaterials exhibiting high biocompatibility, water solubility, functionality, and tunable fluorescence (FL) property. Due to the limitations of batch hydrothermal synthesis in terms of low CDs yield and long synthesis duration, this work aimed to increase its production capacity through a continuous flow reactor system. The influence of temperature and time was first studied in a batch reactor for glucose, xylose, sucrose and table sugar precursors. CDs synthesized from sucrose precursor exhibited the highest quantum yield (QY) (175.48%) and the average diameter less than 10 nm (~6.8 ± 1.1 nm) when synthesized at 220°C for 9 h. For a flow reactor system, the best condition for CDs production from sucrose was 1 mL min flow rate at 280°C, and 0.2 MPa pressure yielding 53.03% QY and ~ 6.5 ± 0.6 nm average diameter (6.6 mg min of CDs productivity). CDs were successfully used as ciprofloxacin (CP) nanocarrier for antimicrobial activity study. The cytotoxicity study showed that no effect of CDs on viability of L-929 fibroblast cells was detected until 1000 µg mL CDs concentration. This finding demonstrates that CDs synthesized via a flow reactor system have a high zeta potential and suitable surface properties for nano-theranostic applications.
碳点(CDs)是一类新型纳米材料,具有高生物相容性、水溶性、功能性和可调节的荧光(FL)特性。由于间歇水热合成在碳点产率低和合成持续时间长方面存在局限性,这项工作旨在通过连续流动反应器系统提高其生产能力。首先在间歇反应器中研究了温度和时间对葡萄糖、木糖、蔗糖和白砂糖前驱体的影响。由蔗糖前驱体合成的碳点在220°C下合成9小时时,表现出最高的量子产率(QY)(175.48%),平均直径小于10nm(约6.8±1.1nm)。对于流动反应器系统,由蔗糖生产碳点的最佳条件是在280°C、流速为1mL/min和压力为0.2MPa下,量子产率为53.03%,平均直径约为6.5±0.6nm(碳点生产率为6.6mg/min)。碳点成功用作环丙沙星(CP)纳米载体用于抗菌活性研究。细胞毒性研究表明,在碳点浓度达到1000µg/mL之前,未检测到碳点对L-929成纤维细胞活力有影响。这一发现表明,通过流动反应器系统合成的碳点具有高zeta电位和适合纳米诊疗应用的表面性质。