Huang Zi-Hao, Wang Li-Ke, Cai Shang-Yu, Chen Hao-Xin, Zhou Yongjin, Cheng Lok-Kan, Lin Yi-Wei, Zheng Ming-Hua, Zheng Yong-Ping
Department of Biomedical Engineering, The Hong Kong Polytechnic University, Hong Kong, China.
School of Biomedical Engineering, Medical School, Shenzhen University, Shenzhen 518000, China.
Diagnostics (Basel). 2024 Jan 15;14(2):0. doi: 10.3390/diagnostics14020189.
Transient elastography (TE), recommended by the WHO, is an established method for characterizing liver fibrosis via liver stiffness measurement (LSM). However, technical barriers remain towards point-of-care application, as conventional TE requires wired connections, possesses a bulky size, and lacks adequate imaging guidance for precise liver localization. In this work, we report the design, phantom validation, and clinical evaluation of a palm-sized TE system that enables simultaneous B-mode imaging and LSM. The performance of this system was validated experimentally using tissue-equivalent reference phantoms (1.45-75 kPa). Comparative studies against other liver elastography techniques, including conventional TE and two-dimensional shear wave elastography (2D-SWE), were performed to evaluate its reliability and validity in adults with various chronic liver diseases. Intra- and inter-operator reliability of LSM were established by an elastography expert and a novice. A good agreement was observed between the Young's modulus reported by the phantom manufacturer and this system (bias: 1.1-8.6%). Among 121 patients, liver stiffness measured by this system and conventional TE were highly correlated ( = 0.975) and strongly agreed with each other (mean difference: -0.77 kPa). Inter-correlation of this system with conventional TE and 2D-SWE was observed. Excellent-to-good operator reliability was demonstrated in 60 patients (ICCs: 0.824-0.913). We demonstrated the feasibility of employing a fully integrated phased array probe for reliable and valid LSM, guided by real-time B-mode imaging of liver anatomy. This system represents the first technical advancement toward point-of-care liver fibrosis assessment. Its small footprint, along with B-mode guidance capability, improves examination efficiency and scales up screening for liver fibrosis.
瞬时弹性成像(TE)是世界卫生组织推荐的一种通过肝脏硬度测量(LSM)来表征肝纤维化的既定方法。然而,由于传统TE需要有线连接、体积庞大且缺乏用于精确肝脏定位的充分成像引导,其在即时检测应用方面仍存在技术障碍。在这项工作中,我们报告了一种手掌大小的TE系统的设计、模型验证和临床评估,该系统能够同时进行B模式成像和LSM。使用组织等效参考模型(1.45 - 75 kPa)对该系统的性能进行了实验验证。针对其他肝脏弹性成像技术,包括传统TE和二维剪切波弹性成像(2D - SWE),进行了对比研究,以评估其在患有各种慢性肝病的成年人中的可靠性和有效性。由一位弹性成像专家和一位新手建立了LSM的操作者内和操作者间可靠性。模型制造商报告的杨氏模量与该系统之间观察到良好的一致性(偏差:1.1 - 8.6%)。在121名患者中,该系统测量的肝脏硬度与传统TE高度相关( = 0.975),且彼此之间高度一致(平均差异:-0.77 kPa)。观察到该系统与传统TE和2D - SWE之间的相互相关性。在60名患者中证明了优异至良好的操作者可靠性(组内相关系数:0.824 - 0.913)。我们证明了在肝脏解剖结构的实时B模式成像引导下,采用完全集成的相控阵探头进行可靠且有效的LSM的可行性。该系统代表了即时检测肝纤维化评估的首个技术进步。其小尺寸以及B模式引导能力提高了检查效率,并扩大了肝纤维化筛查规模。