Comparison of perfluorooctane sulfonate (PFOS), perfluorooctanoic acid (PFOA) and perfluorobutane sulfonate (PFBS) removal in a combined adsorption and electrochemical oxidation process.

This study focused on three of the most studied PFAS molecules, namely perfluorooctane sulfonate (PFOS), perfluorooctanoic acid (PFOA) and perfluorobutane sulfonate (PFBS). They were compared in terms of their adsorption capacity onto graphite intercalated compound (GIC), a low surface area, highly conductive and cheap adsorbent. The adsorption on GIC followed a pseudo second order kinetics and the maximum adsorption capacity using Langmuir was 53.9 μg/g for PFOS, 22.3 μg/g for PFOA and 0.985 μg/g for PFBS due to electrostatic attraction and hydrophobic interactions. GIC was added into an electrochemical oxidation reactor and >100 μg/L PFOS was found to be fully degraded (<10 ng/L) leaving degradation by-products such as PFHpS, PFHxS, PFPeS, PFBS, PFOA, PFHxA and PFBA below 100 ng/L after 5 cycles of adsorption onto GIC for 20 min followed by regeneration at 28 mA/cm for 10 min. PFBS was completely removed due to degradation by aqueous electrons on GIC flakes. Up to 98 % PFOA was removed by the process after 3 cycles of adsorption onto GIC for 20 min followed by regeneration at 25 mA/cm for 10 min. When PFBS was spiked individually, only 17 % was removed due to poor adsorption on GIC. There was a drop of 3-40 % by treating PFOS, PFOA and smaller sulfonates in a real water matrix under the same electrochemical conditions (20 mA/cm), but PFOS and PFOA removal percentage were 95 and 68 % after 20 min at 20 mA/cm.