Water Engineering Department, Shiraz University, Shiraz, Iran.
Chemosphere. 2024 Jun;358:142215. doi: 10.1016/j.chemosphere.2024.142215. Epub 2024 May 1.
The existence of microplastics (MPs) in water is a significant global concern since they have the potential to pose a threat to human health. Therefore, there is a need to develop a sustainable treatment technology for MPs removal, as the conventional methods are inadequate to address this problem. Coagulation is a typical process in treatment plants that can capture MPs before releasing them into the environment. In this work, the removal behaviors of polyamide (PA), polystyrene (PS), and polyethylene (PE) MPs were systematically investigated through coagulation processes using aluminum sulfate (Al(SO)) and Moringa oleifera (MO) seeds extract. Subsequently, the coagulation performance of Al(SO) was improved by the separate addition of anionic polyacrylamide (APAM) and naturally derived MO. Results showed that Al(SO) in combination with APAM had better performance than Al(SO) or MO alone. In the Al(SO)+APAM system, the removal efficiencies were 93.47%, 81.25%, and 29.48% for PA, PS, and PE MPs, respectively. Furthermore, the effectiveness of the Al(SO) and MO blended system was approximately similar to the Al(SO)+APAM system. However, the required amount of Al(SO) was decreased to 50% in the Al(SO)+MO system compared to the optimal dosage in the Al(SO) system alone. The combination of 40 mg/L of Al(SO) and 60 mg/L of MO resulted in removal efficiencies of 92.99%, 80.48%, and 28.94% for PA, PS, and PE MPs, respectively. The high efficacy of these enhanced methods was due to the synergic effects of charge neutralization and agglomeration adsorption, which were validated through zeta potential assessments and visual analysis using scanning electron microscopy (SEM) images. In the case of experimental conditions, initial pH had little impact on removal efficiency, while NaCl salinity and stirring speed directly affected MPs removal. Consequently, this research took a step toward finding a green strategy to remove MPs from water systems.
微塑料(MPs)的存在是一个全球性的重大问题,因为它们有可能对人类健康构成威胁。因此,需要开发一种可持续的 MP 去除处理技术,因为传统方法不足以解决这个问题。混凝是处理厂中的一种典型工艺,可以在将 MPs 释放到环境中之前捕获它们。在这项工作中,通过使用硫酸铝(Al(SO))和辣木种子提取物进行的混凝过程,系统地研究了聚酰胺(PA)、聚苯乙烯(PS)和聚乙烯(PE) MPs 的去除行为。随后,通过单独添加阴离子聚丙烯酰胺(APAM)和天然衍生的辣木来改善 Al(SO) 的混凝性能。结果表明,Al(SO)与 APAM 的组合性能优于 Al(SO)或 MO 单独使用。在 Al(SO)+APAM 体系中,PA、PS 和 PE MPs 的去除效率分别为 93.47%、81.25%和 29.48%。此外,Al(SO)和 MO 混合体系的效果与 Al(SO)+APAM 体系相似。然而,与单独使用 Al(SO)时的最佳剂量相比,在 Al(SO)+MO 体系中所需的 Al(SO)量减少了 50%。当 Al(SO)和 MO 的组合量为 40mg/L 和 60mg/L 时,PA、PS 和 PE MPs 的去除效率分别为 92.99%、80.48%和 28.94%。这些增强方法的高效性归因于电荷中和和凝聚吸附的协同作用,这通过评估动电电位和使用扫描电子显微镜(SEM)图像进行的直观分析得到了验证。在实验条件下,初始 pH 值对去除效率的影响很小,而 NaCl 盐度和搅拌速度直接影响 MPs 的去除。因此,这项研究朝着寻找一种从水系统中去除 MPs 的绿色策略迈出了一步。