Jin Chen, Yu Jiang-Ming, Li Ran, Ye Xiao-Jian
Laboratory of Key Technology and Materials in Minimally Invasive Spine Surgery, Tongren Hospital, Shanghai Jiao Tong University School of Medicine, Shanghai, China.
Center for Spinal Minimally Invasive Research, Shanghai Jiao Tong University, Shanghai, China.
Front Bioeng Biotechnol. 2024 Aug 16;12:1439323. doi: 10.3389/fbioe.2024.1439323. eCollection 2024.
Characterizing the dynamic mechanical properties of spinal cord tissue is deemed important for developing a comprehensive knowledge of the mechanisms underlying spinal cord injury. However, complex viscoelastic properties are vastly underexplored due to the spinal cord shows heterogeneous properties. To investigate regional differences in the biomechanical properties of spinal cord, we provide a mechanical characterization method (i.e., dynamic mechanical analysis) that facilitates robust measurement of spinal cord , at small deformations, in the dynamic regimes. Load-unload cycles were applied to the tissue surface at sinusoidal frequencies of 0.05, 0.10, 0.50 and 1.00 Hz within 2 h . We report the main response features (e.g., nonlinearities, rate dependencies, hysteresis and conditioning) of spinal cord tissue dependent on anatomical origin, and quantify the viscoelastic properties through the measurement of peak force, moduli, and hysteresis and energy loss. For all three anatomical areas (cervical, thoracic, and lumbar spinal cord tissues), the compound, storage, and loss moduli responded similarly to increasing strain rates. Notably, the complex modulus values of spinal cord tissue rose nonlinearly with rising test frequency. Additionally, at every strain rate, it was shown that the tissue in the thoracic spinal cord was significantly more rigid than the tissue in the cervical or lumbar spinal cord, with compound modulus values roughly 1.5-times that of the lumbar region. At strain rates between 0.05 and 0.50 Hz, tan δ values for thoracic (that is, 0.26, 0.25, 0.06, respectively) and lumbar (that is, 0.27, 0.25, 0.07, respectively) spinal cord regions were similar, respectively, which were higher than cervical (that is, 0.21, 0.21, 0.04, respectively) region. The conditioning effects tend to be greater at relative higher deformation rates. Interestingly, no marked difference of conditioning ratios is observed among all three anatomical regions, regardless of loading rate. These findings lay a foundation for further comparison between healthy and diseased spinal cord to the future development of spinal cord scaffold and helps to advance our knowledge of neuroscience.
表征脊髓组织的动态力学特性对于全面了解脊髓损伤的潜在机制至关重要。然而,由于脊髓表现出异质性,其复杂的粘弹性特性尚未得到充分研究。为了研究脊髓生物力学特性的区域差异,我们提供了一种力学表征方法(即动态力学分析),该方法有助于在动态条件下对脊髓进行小变形时的可靠测量。在2小时内,以0.05、0.10、0.50和1.00Hz的正弦频率对组织表面施加加载-卸载循环。我们报告了脊髓组织依赖于解剖学起源的主要响应特征(例如,非线性、速率依赖性、滞后和调节),并通过测量峰值力、模量、滞后和能量损失来量化粘弹性特性。对于所有三个解剖区域(颈髓、胸髓和腰髓组织),复合模量、储能模量和损耗模量对应变率增加的响应相似。值得注意的是,脊髓组织的复数模量值随测试频率的增加而非线性增加。此外,在每个应变率下,研究表明胸髓组织比颈髓或腰髓组织明显更硬,复合模量值约为腰髓区域的1.5倍。在0.05至0.50Hz的应变率下,胸髓(即分别为0.26、0.25、0.06)和腰髓(即分别为0.27、0.25、0.07)区域的tanδ值相似,均高于颈髓(即分别为0.21、0.21、0.04)区域。调节效应在相对较高的变形率下往往更大。有趣的是,无论加载速率如何,在所有三个解剖区域之间均未观察到调节比率的显著差异。这些发现为未来脊髓支架的发展中健康脊髓与患病脊髓的进一步比较奠定了基础,并有助于推进我们对神经科学的认识。