Suppr超能文献

使用光学表面成像进行分次内运动监测的HyperArc立体定向放射外科治疗预处理预演的初步经验。

Initial Experience of Implementing a Pre-treatment Dry Run for HyperArc Stereotactic Radiosurgery Treatments With Optical Surface Imaging for Intra-fraction Motion Monitoring.

作者信息

Wright Eric A, Becker Nathan, Mou Benjamin, Hyde Derek

机构信息

Medical Physics, Hudson Regional Cancer Program, Royal Victoria Regional Health Centre, Barrie, CAN.

Medical Physics, BC Cancer Kelowna, Kelowna, CAN.

出版信息

Cureus. 2024 Nov 6;16(11):e73124. doi: 10.7759/cureus.73124. eCollection 2024 Nov.

Abstract

Linac-based stereotactic radiosurgery (SRS) with planning target volume (PTV) margins <1 mm has become increasingly common in recent years. Optical surface imaging for surface-guided radiation therapy (SGRT) is often used for intra-fraction motion monitoring during these treatments to facilitate the use of a smaller PTV margin by providing real-time quantitative patient positioning information. However, rotating the couch introduces errors to SGRT-reported translations and rotations that can be problematic for SRS treatments with non-coplanar arcs and very small PTV margins. This work presents a novel approach for decreasing the magnitude of these errors by performing a pre-treatment dry run and capturing reference surfaces with the SGRT system at each couch angle included in the treatment plan. Time from cone beam computed tomography (CBCT) to treatment initiation and total treatment session time were reviewed for 30 single-fraction brain SRS cases treated using this technique to determine the effect of including the dry run on treatment session times. Out of the 30 cases treated between April 2023 and January 2024, 23 treatments required only a single CBCT prior to treatment, with no additional mid-treatment imaging required to verify patient positioning after motion. The median time between CBCT and treatment initiation was 7.98 minutes (interquartile range (IQR) = 7.28 to 8.93 minutes). The median time from CBCT to treatment completion was 15.43 minutes (IQR = 13.67 to 21.97 minutes). In the six patients that required one additional CBCT, the treatment session times ranged from 24.32 to 32.83 minutes. There was one patient who required three mid-treatment CBCTs, and the treatment session time was 67.87 minutes. Incorporating the pre-treatment dry run with the acquisition of reference surfaces at each treatment angle decreased errors in SGRT-reported translations and rotations associated with couch rotation without significantly increasing treatment session times.

摘要

近年来,基于直线加速器的立体定向放射外科治疗(SRS)中,计划靶区(PTV)边缘<1mm的情况越来越普遍。用于表面引导放射治疗(SGRT)的光学表面成像常用于这些治疗过程中的分次内运动监测,通过提供实时定量的患者定位信息,便于使用更小的PTV边缘。然而,旋转治疗床会给SGRT报告的平移和旋转带来误差,这对于采用非共面弧和非常小的PTV边缘的SRS治疗可能会有问题。这项工作提出了一种新方法,通过在治疗前进行预演,并在治疗计划中包含的每个治疗床角度用SGRT系统捕获参考表面,来减小这些误差的大小。回顾了使用该技术治疗的30例单次分割脑SRS病例从锥束计算机断层扫描(CBCT)到治疗开始的时间以及总治疗时间,以确定纳入预演对治疗时间的影响。在2023年4月至2024年1月期间治疗的30例病例中,23例治疗仅在治疗前需要一次CBCT,运动后无需额外的治疗中成像来验证患者定位。CBCT与治疗开始之间的中位时间为7.98分钟(四分位间距(IQR)=7.28至8.93分钟)。从CBCT到治疗完成的中位时间为15.43分钟(IQR=13.67至21.97分钟)。在需要额外一次CBCT的6例患者中,治疗时间为24.32至32.83分钟。有1例患者需要3次治疗中CBCT,治疗时间为67.87分钟。在每个治疗角度进行预处理预演并获取参考表面,可减少与治疗床旋转相关的SGRT报告的平移和旋转误差,而不会显著增加治疗时间。

https://cdn.ncbi.nlm.nih.gov/pmc/blobs/8029/11623044/da0308a19461/cureus-0016-00000073124-i01.jpg

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验