Suppr超能文献

1.23% 酸性磷酸氟凝胶温度对恒牙牙釉质微硬度的影响

Effect of Temperature of 1.23% Acidulated Phosphate Fluoride Gel on Enamel Microhardness of Permanent Teeth.

作者信息

Milani Shabnam, Shahrabi Mehdi, M-Abdi Nazanin

机构信息

Department of Pediatric Dentistry, University of British Columbia, Vancouver, Canada.

Department of Pediatric Dentistry, Tehran University of Medical Sciences, Tehran, Iran.

出版信息

Int J Dent. 2024 Dec 5;2024:8227152. doi: 10.1155/ijod/8227152. eCollection 2024.

Abstract

This study aimed to assess the effect of temperature of 1.23% acidulated phosphate fluoride (APF) gel on enamel microhardness of permanent teeth. This in vitro experimental study was conducted on 36 surgically extracted impacted human third molars. The teeth were mounted in acrylic resin and mesiodistally sectioned into buccal and lingual halves by a high-speed cutting saw. The buccal halves of the teeth were polished with silicone carbide abrasive paper and subjected to pH cycling (8 h of immersion in demineralizing agent and 16 h of immersion in remineralizing agent) for 10 days. Their primary enamel microhardness was subsequently measured by a Vickers microhardness tester. The specimens were then randomly assigned to three groups ( = 12) for application of 1.23% APF gel at 4, 25, and 37°C for 4 min. The specimens were then rinsed and incubated for 24 h. Their secondary enamel microhardness was subsequently measured, and the change in microhardness of the specimens was calculated and analyzed by one-way analysis of variance (ANOVA;  = 0.05). The mean percentage of change in microhardness was -0.73% ± 16.8%, -5.28% ± 27.32%, and -7.27% ± 32.28% following the application of APF gel at 4, 25, and 37°C, respectively. The difference among the three groups was not significant regarding the percentage of change in microhardness (  > 0.05). Increasing the temperature of 1.23% APF gel from 4 to 25°C and 37°C did not cause a significant change in enamel microhardness of permanent teeth.

摘要

本研究旨在评估1.23% 酸性磷酸氟(APF)凝胶温度对恒牙牙釉质微硬度的影响。本体外实验研究选取了36颗外科拔除的人类阻生第三磨牙。将牙齿固定在丙烯酸树脂中,用高速切割锯沿近远中方向切成颊侧和舌侧两半。牙齿的颊侧半片用碳化硅砂纸抛光,并进行pH循环(在脱矿剂中浸泡8小时,在再矿化剂中浸泡16小时)10天。随后用维氏显微硬度计测量其初始牙釉质微硬度。然后将标本随机分为三组(每组n = 12),分别在4℃、25℃和37℃下涂抹1.23% APF凝胶4分钟。之后将标本冲洗并孵育24小时。随后测量其二次牙釉质微硬度,并计算标本微硬度的变化,通过单因素方差分析(ANOVA;α = 0.05)进行分析。在4℃、25℃和37℃下涂抹APF凝胶后,微硬度变化的平均百分比分别为-0.73% ± 16.8%、-5.28% ± 27.32%和-7.27% ± 32.28%。三组之间微硬度变化百分比的差异不显著(P > 0.05)。将1.23% APF凝胶的温度从4℃提高到25℃和37℃,恒牙牙釉质微硬度没有显著变化。

相似文献

本文引用的文献

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验