Suppr超能文献

最佳氮素施用量及克隆效应对药用大麻大麻素产量的影响

Optimal nitrogen rates and clonal effects on cannabinoid yields of medicinal cannabis.

作者信息

Dilena Enrico, Hunt Ian, Close Dugald C

机构信息

Tasmanian Institute of Agriculture (TIA), University of Tasmania, Life Sciences Building, Level 2, College Rd, Sandy Bay, TAS, 7005, Australia.

BioSS, Edinburgh University, James Clerk Maxwell Building, Peter Guthrie Tate Road, Edinburgh, Scotland, UK.

出版信息

Sci Rep. 2025 Apr 10;15(1):12341. doi: 10.1038/s41598-025-96761-6.

Abstract

Nitrogen (N) nutrition and germplasm of clones can influence biomass and cannabinoid concentration in medicinal cannabis. However, there are discrepancies on the optimal nitrogen (N) application rate at the flowering stage to achieve maximum yield and if, or how, this interacts with clones from different seed lines of the same genotype. This research examined the relationship between N application rate, concentration of cannabinoids and biomass yield of a CBD-type medicinal cannabis cultivar in clones propagated from five different seed lines (hereafter referred to as clones). Clonal rooted cuttings were propagated from five mother plants germinated from seeds of cultivar 'Tas1'. Five N levels (30, 90, 160, 240 and 400 mg/L N) were imposed at the start of the inflorescence period and continued until harvest eight weeks later. Some pollen contamination occurred during the trial so that seed biomass was assessed for each plant and included in statistical analysis. Weight of total biomass, leaves and inflorescence (from upper and lower canopy positions), N%, and cannabinoid concentrations were measured after the harvest. Results indicated that increasing N supply generated a clear upward trend in inflorescence biomass that peaked at 160 mg/L N after which it did not significantly change, while leaf biomass steadily increased with N. Delta9-tetrahydrocannabinol (THC) and cannabidiol (CBD) concentrations decreased significantly with increasing N concentration in leaves with a similar, but non-significant, trend for inflorescences. The CBD to THC ratio increased with increased N. Clone source was strongly correlated with cannabinoid concentration, but not leaf, inflorescence or total biomass, across all N treatments. Clones 13 and 27 developed greater cannabinoid concentrations relative to clones 18 and 26 irrespective of N treatment. Pollen contamination induced seed development that comprised up to 5% of inflorescence biomass dry weight but this did not significantly affect whole-plant biomass, N accumulation (N%), or cannabinoid concentration. These findings provide valuable insights for improving cannabinoid yield in this widely cultivated plant species.

摘要

氮(N)营养和克隆株的种质会影响药用大麻的生物量和大麻素浓度。然而,在花期实现最大产量的最佳施氮量以及这与同一基因型不同种子系的克隆株之间是否相互作用以及如何相互作用等方面存在差异。本研究考察了从五个不同种子系繁殖的克隆株(以下简称克隆株)中,施氮量、大麻素浓度与CBD型药用大麻品种生物量产量之间的关系。从品种‘Tas1’种子萌发的五株母株上繁殖出克隆生根插条。在花序期开始时设置五个氮水平(30、90、160、240和400mg/L氮),并持续到八周后收获。试验期间发生了一些花粉污染,因此对每株植物的种子生物量进行了评估并纳入统计分析。收获后测量总生物量、叶片和花序(来自树冠上部和下部位置)的重量、氮含量和大麻素浓度。结果表明,增加氮供应使花序生物量呈明显上升趋势,在160mg/L氮时达到峰值,之后没有显著变化,而叶片生物量随氮含量稳步增加。随着叶片中氮浓度的增加,Δ9-四氢大麻酚(THC)和大麻二酚(CBD)浓度显著降低,花序也有类似但不显著的趋势。CBD与THC的比值随氮含量增加而增加。在所有氮处理中,克隆株来源与大麻素浓度密切相关,但与叶片、花序或总生物量无关。无论氮处理如何,克隆株13和27相对于克隆株18和26产生了更高的大麻素浓度。花粉污染导致种子发育,种子生物量占花序生物量干重的比例高达5%,但这对整株植物的生物量、氮积累(氮含量)或大麻素浓度没有显著影响。这些发现为提高这种广泛种植的植物物种中大麻素产量提供了有价值的见解。

https://cdn.ncbi.nlm.nih.gov/pmc/blobs/3191/11985917/bf222f9f872f/41598_2025_96761_Fig1_HTML.jpg

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验