Marcaccio Stephen, Dunn Robin, Arner Justin, Bradley James
Department of Orthopaedic Surgery, University of Pittsburgh Medical Center, Pittsburgh, Pennsylvania, USA.
Video J Sports Med. 2024 Jun 18;4(3):26350254241229099. doi: 10.1177/26350254241229099. eCollection 2024 May-Jun.
When evaluating a patient with a failed anterior cruciate ligament (ACL) reconstruction, a detailed history and physical examination is paramount. The position and size of original femoral and tibial tunnels are critical in the surgical decision-making in the setting of revision ACL reconstruction. This video presents a case of stage I revision ACL reconstruction with the use of allograft bone dowels due to increased size and poor position of original fixation tunnels.
Indications for staging revision ACL reconstruction include significant tunnel osteolysis or dilation (>14 mm), or any situation in which the previous bone tunnels will interfere with anatomic graft placement and fixation.
The patient is placed in the supine position with a standard setup for knee arthroscopy, including lateral thigh post and foot stop for maintained knee flexion at 90°. After diagnostic arthroscopy, the ACL graft remnant is debrided. The femoral tunnel is then debrided and re-cannulated, followed by reaming with cannulated reamers until adequate cortical chatter is achieved, ensuring the presence of a bleeding rim of bone throughout the tunnel to confirm that the correct diameter reamer has been reached. The appropriately sized bone dowel is inserted along the guide pin until fully seated and flush with lateral wall of the notch. This process is then repeated for the tibial tunnel, accessing the tunnel from the previous incision along the medial tibia.
This video presents a technique to achieve adequate bone grafting of previously used tunnels that are not suitable for single-stage revision ACL reconstruction. Patients undergo second-stage revision ACL reconstruction at roughly 4 to 6 months following stage I, when bone graft has fully incorporated on radiographs.
DISCUSSION/CONCLUSION: Stage I revision ACL reconstruction with tunnel grafting using allograft bone dowels is a minimally invasive method of grafting previously used fixation tunnels to allow for anatomic second-stage graft placement and fixation.
The author(s) attests that consent has been obtained from any patient(s) appearing in this publication. If the individual may be identifiable, the author(s) has included a statement of release or other written form of approval from the patient(s) with this submission for publication.
在评估前交叉韧带(ACL)重建失败的患者时,详细的病史和体格检查至关重要。在翻修ACL重建手术决策中,原股骨和胫骨隧道的位置及大小至关重要。本视频展示了一例I期翻修ACL重建病例,该病例因原固定隧道尺寸增大且位置不佳而使用同种异体骨栓。
分期翻修ACL重建的适应症包括明显的隧道骨质溶解或扩张(>14毫米),或任何先前的骨隧道会干扰解剖学移植物放置和固定的情况。
患者仰卧位,采用标准的膝关节镜检查设置,包括大腿外侧支柱和足部固定器,以保持膝关节屈曲90°。诊断性关节镜检查后,清理ACL移植物残端。然后清理股骨隧道并重新插管,接着用空心扩孔钻扩孔,直至获得足够的皮质骨摩擦声,确保整个隧道有出血的骨边缘,以确认已达到正确直径的扩孔钻。沿导针插入尺寸合适的骨栓,直至完全就位并与髁间窝外侧壁齐平。然后对胫骨隧道重复此过程,通过先前沿胫骨内侧的切口进入隧道。
本视频展示了一种技术,可对先前不适合单期翻修ACL重建的隧道进行充分的骨移植。患者在I期手术后约4至6个月进行II期翻修ACL重建,此时X线片显示骨移植已完全融合。
讨论/结论:使用同种异体骨栓进行隧道移植的I期翻修ACL重建是一种微创方法,可对先前使用的固定隧道进行移植,以便进行解剖学II期移植物放置和固定。
作者证明已获得本出版物中出现的任何患者的同意。如果个体可识别,作者已随本投稿附上患者的豁免声明或其他书面批准形式以供发表。