Habener J F, Amherdt M, Ravazzola M, Orci L
J Cell Biol. 1979 Mar;80(3):715-31. doi: 10.1083/jcb.80.3.715.
The formation of parathyroid hormone (PTH) in the parathyroid gland occurs via two successive proteolytic cleavages from larger biosynthetic precursors. The initial product coded for by PTH mRNA is pre-proparathyroid hormone (PreProPTH), a polypeptide of 115 amino acids. Within 1 min of synthesis, the polypeptide, proparathyroid hormone (ProPTH), is formed as a result of the proteolytic removal of the NH2-terminal 25 amino acids from Pre-ProPTH. After a delay of 15-20 min, the NH2-terminal six-amino acid sequence of ProPTH is removed to give PTH of 84 amino acids. To investigate the subcellular sites in the parathyroid cell where the biosynthetic precursors undergo specific proteolytic cleavages, we examined, by electron microscopy autoradiography, the spatiotemporal migration of autoradiographic grains and, by electrophoresis, the kinetics of the disappearance of labeled Pre-ProPTH and the conversion of labeled ProPTH to PTH in bovine parathyroid gland slices incubated with [3H]leucine for 5 min (pulse incubation) followed by incubations with unlabeled leucine for periods up to 85 min (chase incubations). By 5 min, 85% of the autoradiographic grains were confined to the rough endoplasmic reticulum (RER). Autoradiographic grains increased rapidly in number in the Golgi region after 15 min of incubation; from 15 to 30 min they migrated within secretory vesicles still in the Golgi region and then migrated to mature secretory granules outside the Golgi area. Electrophoretic analyses showed that Pre-ProPTH disappeared rapidly (by 5 min) and that conversion of ProPTH to PTH was first detectable at 15 min and was completed by 30 min. At later times of incubation (30-90 min), autoradiographic grains within the secretion glanules migrated to the periphery of the cell and to the plasma membrane, in correlation with the release of PTH first detected by 30 min. We conclude that proteolytic conversion of Pre-ProPTH to ProPTH takes place in the RER and that subsequent conversion of ProPTH to PTH occurs in the Golgi complex.
甲状旁腺激素(PTH)在甲状旁腺中的形成是通过从较大的生物合成前体进行两次连续的蛋白水解切割实现的。由PTH mRNA编码的初始产物是前甲状旁腺激素原(PreProPTH),一种由115个氨基酸组成的多肽。在合成后的1分钟内,由于从PreProPTH中蛋白水解去除氨基末端的25个氨基酸,形成了甲状旁腺激素原(ProPTH)多肽。经过15 - 20分钟的延迟后,ProPTH的氨基末端六氨基酸序列被去除,产生了84个氨基酸的PTH。为了研究甲状旁腺细胞中生物合成前体进行特定蛋白水解切割的亚细胞位点,我们通过电子显微镜放射自显影检查了放射自显影颗粒的时空迁移,并通过电泳研究了用[3H]亮氨酸脉冲孵育5分钟(脉冲孵育)后,在牛甲状旁腺切片中标记的PreProPTH消失的动力学以及标记的ProPTH向PTH的转化,随后用未标记的亮氨酸孵育长达85分钟(追踪孵育)。到5分钟时,85%的放射自显影颗粒局限于粗面内质网(RER)。孵育15分钟后,高尔基体区域的放射自显影颗粒数量迅速增加;从15分钟到30分钟,它们在仍处于高尔基体区域的分泌小泡内迁移,然后迁移到高尔基体区域外的成熟分泌颗粒中。电泳分析表明,PreProPTH迅速消失(在5分钟时),ProPTH向PTH的转化在15分钟时首次可检测到,并在30分钟时完成。在孵育后期(30 - 90分钟),分泌颗粒内的放射自显影颗粒迁移到细胞周边和质膜,这与在30分钟时首次检测到的PTH释放相关。我们得出结论,PreProPTH向ProPTH的蛋白水解转化发生在RER中,随后ProPTH向PTH的转化发生在高尔基体复合体中。