Briggs J P, Schnermann J, Wright F S
Am J Physiol. 1980 Nov;239(5):F427-32. doi: 10.1152/ajprenal.1980.239.5.F427.
Experiments were performed in Sprague-Dawley rats in order to distinguish between sodium chloride and total solute concentration as possible luminal signals capable of eliciting tubuloglomerular feedback responses. Early proximal flow rate (VEP), an index of nephron filtration rate, was measured without perfusion of the loop of Henle and during retrograde perfusion with solutions containing 20, 35, 60 to 100 mM NaCl and varying amounts of either urea or mannitol to achieve total solute concentrations of 130, 280, or 400 mosM. Perfusion flow rate was kept constant at 20 nl/min. Perfusion with a solution containing 20 mM NaCl and made hypo-, iso-, or hypertonic with urea or mannitol caused little or no change in VEP. Perfusion with a 35 mM NaCl solution made hypo-, iso-, or hypertonic with mannitol resulted in a fall of VEP of 6-7 nl/min. When NaCl concentration was 60 mM, VEP fell by 10-14 nl/min with solutions made hypo-, iso-, or hypertonic with urea or mannitol. With 100 mM NaCl solutions made hypo-, iso-, or hypertonic with mannitol, VEP fell approximately 12 nl/min. These results indicate that feedback responses are determined by the NaCl concentration of the perfusate and that this NaCl dependency is not modified by varying perfusate osmolarity between 130 and 400 mosM with urea or mannitol as osmotic agents.
为了区分氯化钠和总溶质浓度作为可能引发球管反馈反应的管腔信号,在斯普拉格-道利大鼠身上进行了实验。在不灌注亨利袢的情况下以及在逆行灌注含20、35、60至100 mM氯化钠以及不同量尿素或甘露醇的溶液以达到130、280或400 mosM总溶质浓度的过程中,测量早期近端流速(VEP),这是肾单位滤过率指标。灌注流速保持恒定在20 nl/min。用含20 mM氯化钠并用尿素或甘露醇制成低渗、等渗或高渗的溶液灌注,对VEP几乎没有影响。用含35 mM氯化钠并用甘露醇制成低渗、等渗或高渗的溶液灌注,导致VEP下降6 - 7 nl/min。当氯化钠浓度为60 mM时,用尿素或甘露醇制成低渗、等渗或高渗的溶液灌注,VEP下降10 - 14 nl/min。用含100 mM氯化钠并用甘露醇制成低渗、等渗或高渗的溶液灌注,VEP下降约12 nl/min。这些结果表明,反馈反应由灌注液中的氯化钠浓度决定,并且这种对氯化钠的依赖性不会因用尿素或甘露醇作为渗透剂将灌注液渗透压在130至400 mosM之间变化而改变。