Gellerich F N, Wagner M, Kapischke M, Wicker U, Brdiczka D
Institut für Biochemie, Medizinische Akademie Magdeburg, Germany.
Biochim Biophys Acta. 1993 May 6;1142(3):217-27. doi: 10.1016/0005-2728(93)90150-e.
Macromolecules as components of the physiological mitochondrial environment were substituted by dextrans of different molecular weight. The addition of 10% dextran (molecular weights varying between 20 and 500 kDa) affected neither basic mitochondrial parameters (state 4 and state 3 respiration) nor kinetic properties of soluble kinases. A significant increase by 10% dextran was however observed of the voltage sensitivity of isolated porin when reconstituted in planar bilayers. The pores adapted the low conducting state already at a voltage of 10 mV. This effect of the macromolecules may explain the higher diffusion resistance of adenine nucleotides across the outer membrane as observed in different experiments: (i) the Michaelis constant of adenylate kinase in the inter-membrane space increased, in contrast to the soluble enzyme, from 118 +/- 10 microM to 193 +/- 20 microM ADP, (ii) in the presence of competing external pyruvate kinase, the mitochondrial utilization of ADP, produced by adenylate kinase in the inter-membrane space, was improved 3-fold suggesting a reduced ADP diffusion out of the outer mitochondrial compartment. The influence of the various dextrans correlated with the increase in molecular weight of the dextrans. The effect on the kinetic constants was dependent on the dextran concentration in terms of weight and not of molarity. The oncotic pressure and viscosity of dextran solutions with different molecular weight showed a comparable dependence. In general, the data indicate that the outer membrane pore responds to an increased oncotic pressure by reducing adenine nucleotide permeability. This suggests the physiological existence of a third adenine nucleotide compartment between the two envelope membranes which may be important especially at high metabolic fluxes.
作为生理线粒体环境组成部分的大分子被不同分子量的葡聚糖所取代。添加10%的葡聚糖(分子量在20至500 kDa之间变化)既不影响线粒体的基本参数(状态4和状态3呼吸),也不影响可溶性激酶的动力学特性。然而,当在平面双层中重构时,观察到10%的葡聚糖使分离的孔蛋白的电压敏感性显著增加。这些孔在10 mV的电压下就适应了低导通状态。大分子的这种作用可能解释了在不同实验中观察到的腺嘌呤核苷酸跨外膜的扩散阻力较高的现象:(i) 与可溶性酶相比,膜间隙中腺苷酸激酶的米氏常数从118±10 μM增加到193±20 μM ADP;(ii) 在存在竞争性外部丙酮酸激酶的情况下,膜间隙中腺苷酸激酶产生的ADP的线粒体利用率提高了3倍,这表明从线粒体外室扩散出的ADP减少。各种葡聚糖的影响与葡聚糖分子量的增加相关。对动力学常数的影响取决于葡聚糖的重量浓度而非摩尔浓度。不同分子量的葡聚糖溶液的渗透压和粘度表现出类似的依赖性。总体而言,数据表明外膜孔通过降低腺嘌呤核苷酸通透性来响应渗透压的增加。这表明在两个包膜之间存在第三个腺嘌呤核苷酸区室,这在生理上可能很重要,尤其是在高代谢通量时。