Stolk M F, van de Heijning B J, van Erpecum K J, van den Broek A M, Renooij W, van Berge-Henegouwen G P
Department of Gastroenterology, University Hospital Utrecht, The Netherlands.
J Hepatol. 1994 Jun;20(6):802-10. doi: 10.1016/s0168-8278(05)80153-9.
Nucleation of cholesterol crystals is thought to occur from cholesterol-phospholipid vesicles. We tested the hypothesis that bile acids are necessary for nucleation of cholesterol crystals. Model bile vesicles were prepared by KBr density ultracentrifugation of supersaturated model bile and mixed with one of the following bile acids: ursodeoxycholate, taurocholate, cholate, chenodeoxycholate or deoxycholate in final concentrations of 3, 30 and 100 mM. Vesicles were also mixed with various combinations of ursodeoxycholate and deoxycholate. Nucleation was assessed semi-quantitatively with polarizing microscopy. After 5 days, samples were again subjected to ultracentrifugation. Addition of 3 and 30 mM taurocholate, cholate, chenodeoxycholate and deoxycholate to vesicles induced nucleation. The extent of nucleation increased significantly with increasing bile acid hydrophobicity: deoxycholate > chenodeoxycholate > cholate > taurocholate (p < 0.05). At 100 mM bile acid this order was reversed (p < 0.05) because most of the cholesterol was solubilized in micelles as shown by ultracentrifugation after 5 days. Percentages of vesicular cholesterol decreased with increasing hydrophobicity: deoxycholate < chenodeoxycholate < cholate < taurocholate (p < 0.05). Ursodeoxycholate did not induce nucleation. At least seven cholesterol crystal shapes could be distinguished and all crystal types could be found after addition of various combinations of ursodeoxycholate+deoxycholate. We conclude that in this model: (a) bile acid species play an important role in the precipitation of cholesterol crystals from model bile vesicles; (b) the more hydrophobic bile acids induce more cholesterol crystal precipitation; and (c) the hydrophobicity of bile acids influences cholesterol crystal morphology.
胆固醇晶体的成核被认为是由胆固醇 - 磷脂囊泡引发的。我们验证了胆汁酸是胆固醇晶体成核所必需的这一假设。通过对过饱和模型胆汁进行溴化钾密度超速离心制备模型胆汁囊泡,并将其与以下胆汁酸之一混合:熊去氧胆酸、牛磺胆酸盐、胆酸盐、鹅去氧胆酸或脱氧胆酸盐,最终浓度分别为3、30和100 mM。囊泡还与熊去氧胆酸和脱氧胆酸的各种组合混合。用偏光显微镜半定量评估成核情况。5天后,样品再次进行超速离心。向囊泡中添加3 mM和30 mM的牛磺胆酸盐、胆酸盐、鹅去氧胆酸和脱氧胆酸会诱导成核。随着胆汁酸疏水性的增加,成核程度显著增加:脱氧胆酸>鹅去氧胆酸>胆酸盐>牛磺胆酸盐(p<0.05)。在100 mM胆汁酸时,这个顺序相反(p<0.05),因为如5天后超速离心所示,大部分胆固醇溶解在微团中。囊泡胆固醇的百分比随着疏水性增加而降低:脱氧胆酸<鹅去氧胆酸<胆酸盐<牛磺胆酸盐(p<0.05)。熊去氧胆酸不会诱导成核。至少可以区分出七种胆固醇晶体形状,并且在添加熊去氧胆酸+脱氧胆酸的各种组合后可以找到所有晶体类型。我们得出结论,在这个模型中:(a)胆汁酸种类在模型胆汁囊泡中胆固醇晶体的沉淀中起重要作用;(b)疏水性越强的胆汁酸诱导更多的胆固醇晶体沉淀;(c)胆汁酸的疏水性影响胆固醇晶体形态。