Sagar A, Rakowski R F
Department of Physiology and Biophysics, University of Health Sciences/Chicago Medical School, Illinois 60064.
J Gen Physiol. 1994 May;103(5):869-93. doi: 10.1085/jgp.103.5.869.
The voltage dependence of steady state current produced by the forward mode of operation of the endogenous electrogenic Na+/K+ pump in Na(+)-loaded Xenopus oocytes has been examined using a two-microelectrode voltage clamp technique. Four experimental cases (in a total of 18 different experimental conditions) were explored: variation of external [Na+] ([Na]o) at saturating (10 mM) external [K+] ([K]o), and activation of pump current by various [K]o at 0, 15, and 120 mM [Na]o (tetramethylammonium replacement). Ionic current through K+ channels was blocked by Ba2+ (5 mM) and tetraethylammonium (20 mM), thereby allowing pump-mediated current to be measured by addition or removal of external K+. Control measurements and corrections were made for pump current run-down and holding current drift. Additional controls were done to estimate the magnitude of the inwardly directed pump-mediated current that was present in K(+)-free solution and the residual K(+)-channel current. A pseudo two-state access channel model is described in the Appendix in which only the pseudo first-order rate coefficients for binding of external Na+ and K+ are assumed to be voltage dependent and all transitions between states in the Na+/K+ pump cycle are assumed to be voltage independent. Any three-state or higher order model with only two oppositely directed voltage-dependent rate coefficients can be reduced to an equivalent pseudo two-state model. The steady state current-voltage (I-V) equations derived from the model for each case were simultaneously fit to the I-V data for all four experimental cases and yielded least-squares estimates of the model parameters. The apparent fractional depth of the external access channel for Na+ is 0.486 +/- 0.010; for K+ it is 0.256 +/- 0.009. The Hill coefficient for Na+ is 2.18 +/- 0.06, and the Hill coefficient for K+ (which is dependent on [Na]o) ranges from 0.581 +/- 0.019 to 1.35 +/- 0.034 for 0 and 120 mM [Na]o, respectively. The model provides a reasonable fit to the data and supports the hypothesis that under conditions of saturating internal [Na+], the principal voltage dependence of the Na+/K+ pump cycle is a consequence of the existence of an external high-field access channel in the pump molecule through which Na+ and K+ ions must pass in order to reach their binding sites.
利用双微电极电压钳技术,研究了钠负载非洲爪蟾卵母细胞中内源性电生钠钾泵正向运转模式产生的稳态电流的电压依赖性。探索了四种实验情况(总共18种不同的实验条件):在饱和(10 mM)外部钾离子浓度([K]o)下改变外部钠离子浓度([Na]o),以及在0、15和120 mM [Na]o(用四甲基铵替代)下通过不同的[K]o激活泵电流。通过钡离子(5 mM)和四乙铵(20 mM)阻断钾离子通道的离子电流,从而通过添加或去除外部钾离子来测量泵介导的电流。对泵电流衰减和保持电流漂移进行了对照测量和校正。还进行了额外的对照,以估计无钾溶液中存在的内向泵介导电流的大小和残余钾离子通道电流。附录中描述了一个伪二态通道模型,其中仅假设外部钠离子和钾离子结合的伪一级速率系数与电压有关,并且假设钠钾泵循环中各状态之间的所有转变与电压无关。任何具有仅两个相反方向电压依赖性速率系数的三态或更高阶模型都可以简化为等效的伪二态模型。针对每种情况从模型推导的稳态电流-电压(I-V)方程同时拟合所有四种实验情况的I-V数据,并得出模型参数的最小二乘估计值。外部钠离子通道的表观分数深度为0.486±0.010;钾离子的为0.256±0.009。钠离子的希尔系数为2.18±0.06,钾离子的希尔系数(取决于[Na]o)在0和120 mM [Na]o时分别为0.581±0.019至1.35±0.034。该模型对数据提供了合理的拟合,并支持以下假设:在内部钠离子饱和的条件下,钠钾泵循环的主要电压依赖性是由于泵分子中存在外部高场通道,钠离子和钾离子必须通过该通道才能到达其结合位点。