Lampert R, Brandt L
Klinik für Anästhesie, Intensivmedizin und Schmerztherapie, Stadt Wuppertal.
Anaesthesist. 1993 Oct;42(10):702-9.
Oximetric measurements are influenced by several mechanisms. Severe jaundice is one of these mechanisms with some clinical interest. In the literature it is pointed out that a high bilirubin concentration may falsify oximetric measurements and is often accompanied by elevated COHb levels. The reason for this phenomenon is thought to be an interference in the absorption spectra of haemoglobin derivatives and bilirubin [2, 3, 4, 10]. In our investigation we attempted to answer the following questions: 1. How do multiwavelength oximeters measure haemoglobin derivatives in different bilirubin concentrations? 2. Do different multiwavelength oximeters give different concentrations of haemoglobin derivatives? METHODS. In 13 patients who developed postoperative jaundice on the intensive care unit, O2Hb, COHb and MetHb were measured in mixed venous blood with two multiwavelength oximeters (OSM3, Radiometer; CO 2500, Ciba-Corning). Bilirubin concentration was measured by the DPD (dichlorphenyldiazonium) method in the central laboratory of our hospital. RESULTS. With increasing bilirubin concentrations, both oximeters measured increasing O2Hb values; the OSM3 consistently showed higher O2Hb concentrations than the CO 2500, with a maximal difference of 2.8% (Fig. 3). Regarding COHb, we saw clear increases in the values with increasing bilirubin concentrations (Fig. 4). The CO 2500 showed higher COHb values than the OSM3 (average 1.54 +/- 0.3%). The findings regarding MetHb differed. The CO 2500 showed increasing MetHb values as the bilirubin concentration increased (Fig. 5). All measurements exceeded normal values above a bilirubin concentration of 17 mg/dl. The OSM3, however, measured constant MetHb values which did not depend on jaundice. CONCLUSIONS. 1. The in vitro measurement of haemoglobin derivates by multiwavelength oximeters is influenced by hyperbilirubinaemia. This is caused by an interference between the light absorption spectra of the haemoglobin derivates and of bilirubin and by the increasing development of endogenous CO in the haem metabolism during severe jaundice (Fig. 7). 2. With increasing bilirubin levels, a lower O2Hb is measured with the CO 2500 than with the OSM3. 3. We also see increasing COHb values with rising bilirubin concentrations. 4. With increasing bilirubin levels the MetHb concentration measured with the CO 2500 rises, while the OSM3 gives constant MetHb values. 5. In severe jaundice the O2Hb values measured with multiwavelength oximeters are not identical with the real blood concentration of this haemoglobin derivative. In this situation multiwavelength oximeters cannot be used as a reference method for in vivo oximetric systems such as pulse oximeters or fibreoptic pulmonary artery catheters.
血氧饱和度测量受多种机制影响。严重黄疸是其中一种具有一定临床意义的机制。文献指出,高胆红素浓度可能会使血氧饱和度测量结果失真,且常伴有碳氧血红蛋白(COHb)水平升高。这种现象的原因被认为是血红蛋白衍生物和胆红素的吸收光谱存在干扰[2,3,4,10]。在我们的研究中,我们试图回答以下问题:1. 多波长血氧仪如何测量不同胆红素浓度下的血红蛋白衍生物?2. 不同的多波长血氧仪给出的血红蛋白衍生物浓度是否不同?方法。在重症监护病房发生术后黄疸的13例患者中,使用两台多波长血氧仪(OSM3,Radiometer公司;CO 2500,Ciba-Corning公司)测量混合静脉血中的氧合血红蛋白(O2Hb)、碳氧血红蛋白和高铁血红蛋白(MetHb)。胆红素浓度在我院中心实验室采用DPD(二氯苯基重氮)法测量。结果。随着胆红素浓度升高,两台血氧仪测得的O2Hb值均升高;OSM3测得的O2Hb浓度始终高于CO 2500,最大差值为2.8%(图3)。关于COHb,我们发现随着胆红素浓度升高其值明显增加(图4)。CO 2500测得的COHb值高于OSM3(平均1.54±0.3%)。关于MetHb的结果有所不同。CO 2500测得的MetHb值随着胆红素浓度升高而增加(图5)。胆红素浓度高于17mg/dl时,所有测量值均超过正常范围。然而,OSM3测得的MetHb值保持恒定,与黄疸无关。结论。1. 多波长血氧仪对血红蛋白衍生物的体外测量受高胆红素血症影响。这是由于血红蛋白衍生物和胆红素的光吸收光谱相互干扰,以及严重黄疸期间血红素代谢中内源性CO生成增加所致(图7)。2. 随着胆红素水平升高,CO 2500测得的O2Hb低于OSM3。3. 我们还发现随着胆红素浓度升高,COHb值增加。4. 随着胆红素水平升高,CO 2500测得的MetHb浓度升高,而OSM3测得的MetHb值保持恒定。5. 在严重黄疸时,多波长血氧仪测得的O2Hb值与该血红蛋白衍生物的实际血液浓度不一致。在这种情况下,多波长血氧仪不能用作诸如脉搏血氧仪或光纤肺动脉导管等体内血氧测量系统的参考方法。