Suppr超能文献

压力对单室大藻细胞膜电击穿的影响。

The effect of pressure on the electrical breakdown in the membranes of Valonia utricularis.

作者信息

Zimmermann U, Beckers F, Coster H G

出版信息

Biochim Biophys Acta. 1977 Jan 21;464(2):399-46. doi: 10.1016/0005-2736(77)90014-1.

Abstract

The interpretation of electrical breakdown in terms of electro-mechanical instabilities, predicts that the breakdown potential should decrease with increasing cell turgor pressure. Experiments were conducted to test this hypothesis on cells of Valonia utricularis over a turgor pressure range of 0.5-10(5)-5.0-10(5) N/m2. Electrical breakdown was measured using intracellular electrodes and 500 mus current pulses. The pressure was monitored by an intracellular micropipette pressure transducer. The results obtained show a linear decrease in the critical breakdown potential with pressure. The effective compressive modulus of the cell membrane, gamma, is calculated from the slope of this line to 69+/-10-10(5) N/m2 (average value of seven measurements). This is consistent with the theoretical prediction of the electromechanical model using our previously determined values of the elastic modulus of the membrane. A theoretical analysis is given of the effects of pressure on the breakdown, This includes also considerations of the indirect effect of pressure on the membrane via stretching of the cell wall with a possible coupling of such strains to the cell membrane. The results and analysis presented allow us to conclude on the basis of the experimentally determined breakdown P.K. of 959 mV that the region of membrane where electrical breakdown occurs is a dielectric with one of the following combinations of parameters: (A) a thickness delta=7-9 nm with a dielectric constant epsilon=greater than 10, e.g. a hydrated protein spanning the whole membrane. (B) delta=4-5 nm with epsilon=3-8, e.g. a lipoprotein of lipid bilayer dimensions. (C) delta approximately 2 nm with epsilon=2-3, e.g. a half lipid bilayer. If we assume that the breakdown P.D. of the tonoplast and plasmalemma are identical, that is 480 mV, then there is only one reasonable choice for the membrane thickness and the dielectric constant: delta=2 nm, epsilon=3-8, e.g. a (lipo) proteinaceous module facing a half life lipid bilayer.

摘要

根据机电不稳定性对电击穿进行的解释预测,击穿电位应随细胞膨压的增加而降低。在膨压范围为0.5 - 10⁵ - 5.0 - 10⁵ N/m²的条件下,对囊状瓦罗藻细胞进行了实验以验证这一假设。使用细胞内电极和500 μs电流脉冲测量电击穿。通过细胞内微吸管压力传感器监测压力。所得结果表明临界击穿电位随压力呈线性下降。根据该直线斜率计算出细胞膜的有效压缩模量γ为69±10 - 10⁵ N/m²(七次测量的平均值)。这与使用我们先前确定的膜弹性模量值的机电模型的理论预测一致。给出了压力对击穿影响的理论分析。这还包括考虑压力通过细胞壁拉伸对膜的间接影响,以及这种应变与细胞膜的可能耦合。所呈现的结果和分析使我们能够根据实验确定的959 mV的击穿P.K.得出结论,即发生电击穿的膜区域是一种具有以下参数组合之一的电介质:(A) 厚度δ = 7 - 9 nm,介电常数ε > 10,例如跨越整个膜的水合蛋白质。(B) δ = 4 - 5 nm,ε = 3 - 8,例如脂质双层尺寸的脂蛋白。(C) δ约为2 nm,ε = 2 - 3,例如半脂质双层。如果我们假设液泡膜和质膜的击穿P.D.相同,即480 mV,那么对于膜厚度和介电常数只有一个合理的选择:δ = 2 nm,ε = 3 - 8,例如面向半寿命脂质双层的(脂)蛋白质模块。

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验