Ravenscraft S A, Burke W C, Nahum A, Adams A B, Nakos G, Marcy T W, Marini J J
Division of Pulmonary and Critical Care Medicine, University of Minnesota, Minneapolis/St. Paul.
Am Rev Respir Dis. 1993 Aug;148(2):345-51. doi: 10.1164/ajrccm/148.2.345.
A technique that improves the efficiency of alveolar ventilation should decrease the pressure required and reduce the potential for lung injury during mechanical ventilation. Alveolar ventilation may be improved by replacing a portion of the anatomic dead space with fresh gas via an intratracheal catheter. We studied the effect of intratracheal gas insufflation as an adjunct to volume cycled ventilation in eight sedated, paralyzed patients with a variety of lung disorders. Continuous flows of 2, 4, and 6 L/min were delivered through a catheter positioned 1 or 10 cm above the carina. Carbon dioxide production, inspiratory minute ventilation, and peak and mean airway pressures did not change over the range of flows tested. PaCO2 and dead space volume/tidal volume decreased significantly as joint functions of catheter flow and position (p < 0.001). The highest catheter flow (6 L/min) and most distal catheter position (1 cm above the carina) were the most effective combination tested, averaging a 15% reduction in PaCO2 (range 9 to 23%). Certain characteristics of the expiratory capnogram were helpful in predicting the observed reduction in PaCO2. Tracheal gas insufflation may eventually prove a useful adjunct to a pressure-targeted strategy of ventilatory management (in either volume-cycled or pressure controlled modes), particularly when the total dead space is heavily influenced by its anatomic component.
一种提高肺泡通气效率的技术应能降低所需压力,并减少机械通气期间肺损伤的可能性。通过气管内导管用新鲜气体替代部分解剖无效腔,可改善肺泡通气。我们研究了气管内气体吹入作为容量控制通气辅助手段对8例患有各种肺部疾病的镇静、麻痹患者的影响。通过置于隆突上方1或10 cm处的导管输送2、4和6 L/min的持续气流。在测试的气流范围内,二氧化碳产生量、吸气分钟通气量以及气道峰压和平均压均未改变。作为导管气流和位置的联合函数,PaCO2和无效腔容积/潮气量显著降低(p<0.001)。最高的导管气流(6 L/min)和最远端的导管位置(隆突上方1 cm)是测试的最有效组合,平均使PaCO2降低15%(范围为9%至23%)。呼气末二氧化碳图的某些特征有助于预测观察到的PaCO2降低情况。气管内气体吹入最终可能被证明是通气管理压力目标策略(无论是容量控制模式还是压力控制模式)的有用辅助手段,特别是当总无效腔受解剖成分严重影响时。