Coffee C J, Solano C
J Biol Chem. 1977 Mar 10;252(5):1606-12.
The kinetic and regulatory properties of homogeneous AMP deaminase from rat skeletal muscle have ben examined with particular emphasis on (a) the role of potassium ions in the expression of these properties and (b) the role of the adenylate energy charge in the regulation of AMP deaminase activity. Although the enzyme has an absolute requirement for K+, the concentration required for maximum activation is dependent on the concentration of substrate. At saturating levels of AMP (greater than or equal 2.0 mM) maximum activation is observed with 25 mM KCl, whereas at lower substrate concentrations (0.2 mM) approximately 50 mM KCl is needed for maximum activation. Conversely, the response of enzyme activity ot increasing levels of substrate is dependent on the level of potassium ions. At substrating concentrations of K+, the saturation curve for AMP is highly sigmoidal (nh=3.2) whereas at higher KCl concentrations, the apparent cooperativity between AMP sites is almost completely abolished (nh=1.5). The inhibition by a number of phosphorylated metabolites, including ATP, GTP, creatine-P, and P1, is likewise sensitive to the concentration of K+. These results suggest that a significant amount of interaction between K+ sites and both substrate and effector sites is required for the expression of the catalytic and regulatory properties of the enzyme. The specific effects of ATP, creatine-P, and P1 on the parameters of Km and Vmax indicate that each of these profile of AMP deaminase activity generated in response to variations in the adenylate energy charge shows that within the physiological range of energy charge (0.75 to 0.95), the activity increases linearly with decreasesing energy charge and is insensitive to both the total adenylate pool size and the presence of P1 and creatine-P. These data suggest that the most important factor in the regulation of AMP deaminase activity is the state of the energy charge rather than the absolute concentrations of the individual effectors.
已对来自大鼠骨骼肌的纯一AMP脱氨酶的动力学和调节特性进行了研究,特别着重于(a)钾离子在这些特性表达中的作用,以及(b)腺苷酸能荷在调节AMP脱氨酶活性中的作用。尽管该酶对K⁺有绝对需求,但最大激活所需的浓度取决于底物浓度。在AMP饱和水平(大于或等于2.0 mM)时,25 mM KCl可观察到最大激活,而在较低底物浓度(0.2 mM)时,大约需要50 mM KCl才能达到最大激活。相反,酶活性对底物水平升高的反应取决于钾离子水平。在低K⁺浓度下,AMP的饱和曲线呈高度S形(nₕ = 3.2),而在较高KCl浓度下,AMP位点之间的表观协同性几乎完全消失(nₕ = 1.5)。包括ATP、GTP、肌酸 - P和P₁在内的多种磷酸化代谢物的抑制作用同样对K⁺浓度敏感。这些结果表明,K⁺位点与底物和效应物位点之间需要大量相互作用,才能表达该酶的催化和调节特性。ATP、肌酸 - P和P₁对Km和Vmax参数的具体影响表明,这些物质中的每一种对响应腺苷酸能荷变化而产生的AMP脱氨酶活性曲线的影响表明,在能荷的生理范围内(0.75至0.95),活性随能荷降低呈线性增加,并且对总腺苷酸库大小以及P₁和肌酸 - P的存在均不敏感。这些数据表明,调节AMP脱氨酶活性的最重要因素是能荷状态,而不是各个效应物的绝对浓度。