Iced temperature injectate for thermodilution cardiac output determination causes minimal effects on cardiodynamics.

OBJECTIVES

Controversy exists regarding the ideal injectate temperature for measuring cardiac output. Iced temperature injectate gives a higher signal/noise ratio and less variability in the measured cardiac output. Thus, less volume and fewer measurements are required. Advocates of room temperature injectate have suggested that iced temperature injectate may perturb cardiodynamics. This concern has remained largely untested. To help resolve this controversy, we examined the effects of 5 mL iced injectate (0 degrees to 4 degrees) infusions on cardiodynamics.

DESIGN

Prospective, randomized, controlled study.

SETTING

A critical care research laboratory.

SUBJECTS

Five domestic pigs, weighing between 20 to 25 kg.

INTERVENTIONS

Under barbiturate anesthesia, pigs underwent placement of a) a thermodilution catheter in the right internal jugular vein; b) a right carotid artery catheter for mean arterial pressure; and c) sonomicrometry crystals for dynamic measurements of left ventricular dimensions. Calculations were made of end-systolic and end-diastolic left ventricular volume and ejection fraction. Six cardiac output measurements were performed in each pig. Data were obtained at baseline (just before iced temperature injectate infusion) and every 3 sec for 9 secs.

MEASUREMENTS AND MAIN RESULTS

The only significant effect seen with iced temperature injectate infusion was a small, transient decrease in heart rate (-5.9 +/- 1.1 beats/min from a baseline heart rate of 144.8 +/- 20.6 beats/min). Indices of preload, contractile function, and dynamic cardiac geometry were unaffected.

CONCLUSIONS

Iced temperature injectate used in clinically relevant volumes causes transient negative chronotropic effects, but reservations regarding other perturbations of cardiodynamics are unfounded. Thus, the use of iced temperature injectate for cardiac output determination is still a viable alternative to room temperature injectate use, especially when a larger signal/noise ratio is required.