Ebraheim N A, Rollins J R, Xu R, Yeasting R A
Department of Orthopaedic Surgery, Medical College of Ohio, Toledo, USA.
Spine (Phila Pa 1976). 1996 Jun 1;21(11):1296-300. doi: 10.1097/00007632-199606010-00003.
This study defined the projection point of the lumbar pedicle on its posterior aspect and its relation to a reliable landmark and reported pedicle dimensions based on 50 lumbar spines.
To establish the best starting point for a pedicle screw for passing the screw down the center (axis) of the pedicle; to describe quantitatively the relations of the pedicle projection point to a reliable landmark; and to evaluate the linear and angular dimensions of the lumbar pedicle.
Posterior transpedicular screw fixation has been most widely used for management of the unstable lumbar spine. Several studies of pedicular anatomy exist, but little quantitative data regarding the location of the lumbar pedicle axis for each level have been reported.
Fifty dry lumbar specimens (250 lumbar vertebrae) were obtained for study of the lumbar pedicle. Anatomic evaluation focused on determination of the projection point of the lumbar pedicle axis on the junction of the superior facet and the transverse process and measured the distance from the projection point to the midline of the transverse process for each level of the lumbar vertebrae. Pedicle dimensions, including linear and angular, also were measured.
Differences in dimensions between men and women were not found to be statistically significant. The average distance from the projection point to the midline of the transverse process consistently changed from L1 to L5. Above L4, the projection point for men and women averaged 3.9 mm for L1, 2.8 mm for L2, and 1.4 mm for L3 superior to the midline of the transverse process, respectively. At L4, the projection point was close to the midline of the transverse process (0.5 mm inferior). At L5, the projection point was an average of 1.5 mm inferior to the midline of the transverse process.
The average distance from the projection point of the lumbar pedicle axis to the midline of the transverse process consistently varied at different levels. This information may prove helpful in the placement of screws into the lumbar pedicle.
本研究确定了腰椎椎弓根在其后侧的投影点及其与一个可靠标志的关系,并报告了基于50个腰椎标本的椎弓根尺寸。
确定椎弓根螺钉的最佳起始点,以便使螺钉沿椎弓根中心(轴线)置入;定量描述椎弓根投影点与一个可靠标志的关系;评估腰椎椎弓根的线性和角度尺寸。
后路经椎弓根螺钉固定术已最广泛地用于不稳定腰椎的治疗。已有多项关于椎弓根解剖的研究,但关于每个腰椎节段椎弓根轴线位置的定量数据报道较少。
获取50个干燥的腰椎标本(250个腰椎椎体)用于腰椎椎弓根研究。解剖学评估重点在于确定腰椎椎弓根轴线在关节突与横突交界处的投影点,并测量每个腰椎节段投影点到横突中线的距离。还测量了椎弓根的尺寸,包括线性和角度尺寸。
未发现男性和女性在尺寸上的差异具有统计学意义。从投影点到横突中线的平均距离在L1至L5之间持续变化。在L4以上,男性和女性的投影点在L1时分别平均位于横突中线以上3.9毫米、L2时为2.8毫米、L3时为1.4毫米。在L4时,投影点接近横突中线(下方0.5毫米)。在L5时,投影点平均位于横突中线下方1.5毫米。
腰椎椎弓根轴线投影点到横突中线的平均距离在不同节段持续变化。这一信息可能有助于将螺钉置入腰椎椎弓根。