Ebraheim N A, Xu R, Ahmad M, Yeasting R A
Department of Orthopaedic Surgery, Medical College of Ohio, Toledo, USA.
Spine (Phila Pa 1976). 1997 Feb 1;22(3):233-8. doi: 10.1097/00007632-199702010-00001.
This study defined the projection point of the thoracic pedicles on their posterior aspect and its relation to a reliable landmark. It also reported pedicle dimensions based on 43 thoracic spines.
To determine the projection point of the pedicle axis on the posterior aspect of the thoracic spine, quantitatively describe relations of the projection point to some reliable landmarks, and evaluate linear and angular dimensions of the thoracic pedicle.
Posterior segmental screw fixation is the current standard of internal fixation at the level of the second lumbar vertebrae or below. However, pedicular screw fixation in the thoracic spine, especially in the middle and upper thoracic region, is not common because the small dimensions of the pedicle in this region make screw insertion difficult. More information about pedicle axis projection (not pedicle zone) and its quantitative relationship to some reliable landmarks is essential.
Forty-three dry thoracic specimens (516 vertebrae) were obtained for study of the thoracic pedicle. Anatomic evaluation focused on the determination of the projection point of the thoracic pedicle axis on its posterior aspect and the anatomic relationship of this point to the lateral edge of superior facet and the midline of the transverse process. Also, pedicle dimensions, including linear and angular, were measured. The mean, range, and standard deviation were calculated for all of the specimens and for male and female specimens separately.
Sexual difference was found to be significant statistically in more than half of parameters. For T1-T2, the projection point of the pedicle axis was approximately 7-8 mm medial to the lateral edge of the superior facet and 3-4 mm superior to the midline of the transverse process. For T3-T12, this point was 4-5 mm medial to the lateral margin of the facet and 5-8 mm superior to the midline of the transverse process. The transverse angle of the pedicle axis was found to be 30-40 degrees at T1-T2, 20-25 degrees at T3-T11, and 10 degrees at T12.
This information, in conjunction with preoperative computed tomography evaluation, may enhance our knowledge of transpedicular screw fixation in the thoracic pedicle.
本研究确定了胸椎椎弓根在其后侧的投影点及其与一个可靠标志的关系。同时,基于43个胸椎棘突报告了椎弓根尺寸。
确定胸椎椎弓根轴线在胸椎后侧的投影点,定量描述该投影点与一些可靠标志的关系,并评估胸椎椎弓根的线性和角度尺寸。
后路节段性螺钉固定是目前第二腰椎及以下水平内固定的标准方法。然而,胸椎椎弓根螺钉固定,尤其是在胸段中上区域并不常见,因为该区域椎弓根尺寸较小,使得螺钉置入困难。更多关于椎弓根轴线投影(而非椎弓根区域)及其与一些可靠标志的定量关系的信息至关重要。
获取43个胸椎干燥标本(516个椎体)用于胸椎椎弓根研究。解剖学评估重点在于确定胸椎椎弓根轴线在其后侧的投影点,以及该点与上关节突外侧缘和横突中线的解剖关系。此外,测量了椎弓根的尺寸,包括线性和角度尺寸。分别计算了所有标本以及男性和女性标本的平均值、范围和标准差。
在超过一半的参数中发现性别差异具有统计学意义。对于T1 - T2,椎弓根轴线投影点在上关节突外侧缘内侧约7 - 8毫米处,在横突中线以上3 - 4毫米处。对于T3 - T12,该点在关节突外侧缘内侧4 - 5毫米处,在横突中线以上5 - 8毫米处。发现椎弓根轴线的横角在T1 - T2为30 - 40度,在T3 - T11为20 - 25度,在T12为10度。
这些信息,结合术前计算机断层扫描评估,可能会增进我们对胸椎椎弓根螺钉固定的了解。