Hefzy M S, Kelly B P, Cooke T D
Department of Biological and Medical Research, King Faisal Specialist Hospital and Research Center, Riyadh, Saudi Arabia.
Med Eng Phys. 1998 Jun;20(4):302-7. doi: 10.1016/s1350-4533(98)00024-1.
The purpose of this study is to describe the kinematics of normal knees in vivo, assessed in deep flexion, using bi-planar radiographs. Antero-posterior and lateral views were obtained from five healthy males during three sequential positions of kneeling. In the first position, the subject knelt with the knees fully flexed (deep flexion between 150 and 165 degrees) and torso upright. In the second position, the subject bowed forward to an intermediate position (about 120 degrees of knee flexion). In the third position, the subject bowed further until his head touched the floor, supporting the upper torso with hands and with the knees flexed at about 90 degrees. The results show that past 135 degrees of knee flexion, the patella cleared the femoral groove and was in contact only with the condyles. For these particular postures, and during deep flexion, motion of the femur on the tibia did not reveal the classical femoral 'roll back'. Rather the lateral femoral condyle rolled further over the postero medial aspect of the lateral tibial plateau while contact of the medial femoral condyle occurred more anteriorly, but still in the posterior part of the medial plateau. This asymmetric rolling motion indicated an element of internal tibial rotation. Furthermore, the tibia was found to articulate with the femur at the most proximal points of the condyles in deep flexion. These data on the kinematics and contact characteristics of the tibio-femoral joint must be considered in any approach to design for a Deep Flexion Knee Implant.
本研究的目的是利用双平面X线片描述体内正常膝关节在深度屈曲时的运动学。在5名健康男性屈膝的三个连续位置获取前后位和侧位影像。在第一个位置,受试者双膝完全屈曲(深度屈曲在150至165度之间)且躯干挺直地跪着。在第二个位置,受试者向前弯腰至中间位置(膝关节屈曲约120度)。在第三个位置,受试者进一步弯腰直到头部触地,用手支撑上半身,膝关节屈曲约90度。结果显示,膝关节屈曲超过135度时,髌骨离开股骨髁间沟,仅与髁接触。对于这些特定姿势以及深度屈曲过程中,股骨在胫骨上的运动未显示出典型的股骨“后滚”。相反,外侧股骨髁在外侧胫骨平台后内侧进一步滚动,而内侧股骨髁的接触更靠前,但仍在内侧平台的后部。这种不对称滚动运动表明存在胫骨内旋成分。此外,发现在深度屈曲时胫骨在髁的最近端与股骨形成关节。在设计深度屈曲膝关节植入物的任何方法中,都必须考虑这些关于胫股关节运动学和接触特征的数据。