Kleber C J, Putt M S, Nelson B J
Indiana University, Fort Wayne, USA.
J Clin Dent. 1998;9(1):16-21.
The main purpose of this laboratory study was to determine the tooth whitening effect of a baking soda dentifrice containing stabilized 1% hydrogen peroxide following repeated applications to intrinsically stained teeth. Additional objectives were to investigate (1) the influence of tooth surface curvature and moisture on color measurements, (2) preliminary treatment parameters using 1% hydrogen peroxide solution, and (3) the relationship between Vita shade guide standards and instrumental color readings. Human tooth specimens with intrinsic stain were specially prepared and measured for color (Lab*) by means of diffuse reflectance spectrophotometry. Specimens were measured under wet and dry conditions with natural and flattened enamel surfaces. A preliminary test was conducted with 1% H2O2 solution to establish tooth whitening versus treatment time. Then, new tooth specimens were treated repeatedly with slurries of silica, baking soda, or baking soda/peroxide dentifrices at 30-minute intervals, and color measurements were taken under both wet and dry conditions after 4, 8, 16 and 24 hours. Lab* color measurements of the Vita shade guide teeth were also made in order to relate laboratory color changes to clinical effects. The parameter testing results showed that flattening the enamel surface had no effect on tooth color, but the teeth rapidly became lighter and less yellow upon air-drying. The 1% H2O2 solution caused both a significant decrease in yellow (b*) and an increase in lightness (L*). Since the reduction for b* occurred more rapidly and to a greater extent than the L* factor, the b* component may be the more important indicator of tooth whitening by bleaching. Compared to the silica and baking soda dentifrices, the baking soda/peroxide dentifrice significantly decreased the yellow color (b*) of the teeth after 8 or more hours of topical treatment. The instrumental color readings of the Vita Shade guide teeth showed that the color differences between the standards were not linear or consistent, and their accuracy for assessing clinical changes in tooth whiteness is questionable.
本实验室研究的主要目的是确定一种含有稳定化1%过氧化氢的小苏打牙膏在反复应用于内源性染色牙齿后牙齿美白效果。其他目标包括研究:(1)牙齿表面曲率和湿度对颜色测量的影响;(2)使用1%过氧化氢溶液的初步治疗参数;(3)Vita比色板标准与仪器颜色读数之间的关系。制备了具有内源性染色的人牙标本,并通过漫反射分光光度法测量颜色(Lab*)。在湿润和干燥条件下,对具有天然和平坦釉质表面的标本进行测量。用1%过氧化氢溶液进行了初步试验,以确定牙齿美白与治疗时间的关系。然后,用二氧化硅、小苏打或小苏打/过氧化物牙膏的糊剂以30分钟的间隔反复处理新的牙齿标本,并在4、8、16和24小时后在湿润和干燥条件下进行颜色测量。还对Vita比色板牙齿进行了Lab颜色测量,以便将实验室颜色变化与临床效果联系起来。参数测试结果表明,使釉质表面变平对牙齿颜色没有影响,但牙齿在风干后迅速变亮且变黄程度降低。1%过氧化氢溶液导致黄色(b)显著降低,亮度(L*)增加。由于b的降低比L因子发生得更快且程度更大,b成分可能是漂白牙齿美白的更重要指标。与二氧化硅和小苏打牙膏相比,小苏打/过氧化物牙膏在局部治疗8小时或更长时间后显著降低了牙齿的黄色(b)。Vita比色板牙齿的仪器颜色读数表明,标准之间的颜色差异不是线性或一致的,其评估牙齿美白临床变化的准确性值得怀疑。