Salih E
Department of Chemistry, Brandeis University, Waltham, MA 02254.
Biochem J. 1992 Jul 15;285 ( Pt 2)(Pt 2):451-60. doi: 10.1042/bj2850451.
Low 2H2O effects (1.0-1.5) for the parameter k(cat.)/Km in the hydrolysis of various substrates by acetylcholinesterase (AcChE) is due to normal 2H2O effects (1.8-2.8) for the parameter k(cat.) and 2H2O effects of 1.0-2.5 for the parameter Km. The analyses and interpretations of 2H2O effects in the literature utilizing the parameter k(cat.)/Km, which led to the proposal of 'isotope insensitivity' of the catalytic steps and the hypothesis of a rate-limiting substrate-induced-fit conformational change, are incorrect. Since k(cat.) is the only parameter that can represent the hydron-transfer step solely, the 2H2O effect can most appropriately be evaluated by using this parameter. Calculations and comparison of acylation (k+2) and deacylation (k+3) rate constants show that acylation is rate-determining for most substrates and the improved binding -0.84 to -2.09 kJ/mol (-0.2 to -0.5 kcal/mol) in 2H2O obscures the normal 2H2O effect on k(cat.) when the ratio k(cat.)/Km is utilized. Consistent with this, measurements of the inhibition constant (KI(com.)) for a reversible inhibitor, phenyltrimethylammonium, lead to KI(com.)H2O = 39 +/- 3 microM and KI(com.)2H2O = 24.5 +/- 3.5 microM, an 2H2O effect of 1.59 +/- 0.26. pH-dependence of k(cat.) in 2H2O is subject to variability of the pK(app.) values, as evaluated in terms of the two-hydronic-reactive states (EH and EH2) of AcChE, and is due to an uneven decrease in 2H2O of the kinetic parameters k'cat. for the EH2 state relative to k(cat.) for the EH state, thus leading to variable shifts in pK(app.) values of between 0.5 and 1.2 pH units for this parameter. The observed pH-independent limiting rate constants for k(cat.)/Km(app.) are made to vary between 0.5 and 1.0 in 2H2O by effects on kinetic parameters for the EH2 state, k'cat./K'm varying between 0.2 and 0.7 relative to the EH state, with k(cat.)/Km varying between 0.4 and 1.0. The effects observed on k(cat.)/Km(app.) are ultimately the result of variable effects of 2H2O on k'cat. and K'm for the EH2 state relative to k(cat.) and Km for the EH state of AcChE. These effects are responsible for the variable shifts and more than 0.5 pH unit of the pK(app.) values in 2H2O for pH-k(cat.)/Km profiles. The upward-bowing hydron inventories for k(cat.)/Km are the result of linear hydron inventories for k(cat.) and downward-bowing on Km and are not due to the rate-limiting substrate-induced fit process as claimed in the literature.(ABSTRACT TRUNCATED AT 400 WORDS)
乙酰胆碱酯酶(AcChE)对各种底物水解时,参数k(cat.)/Km的低2H2O效应(1.0 - 1.5)是由于参数k(cat.)的正常2H2O效应(1.8 - 2.8)以及参数Km的2H2O效应为1.0 - 2.5。文献中利用参数k(cat.)/Km对2H2O效应进行的分析和解释是不正确的,这些分析和解释导致了催化步骤“同位素不敏感性”的提出以及限速底物诱导契合构象变化的假设。由于k(cat.)是唯一能单独代表氢转移步骤的参数,因此通过使用该参数能最恰当地评估2H2O效应。酰化(k+2)和脱酰化(k+3)速率常数的计算与比较表明,对于大多数底物,酰化是速率决定步骤,在2H2O中-0.84至-2.09 kJ/mol(-0.2至-0.5 kcal/mol)的结合改善,当使用k(cat.)/Km比值时,会掩盖2H2O对k(cat.)的正常效应。与此一致的是,对可逆抑制剂苯基三甲基铵的抑制常数(KI(com.))的测量得出KI(com.)H2O = 39 ± 3 μM和KI(com.)2H2O = 24.5 ± 3.5 μM,2H2O效应为1.59 ± 0.26。根据AcChE的两种氢反应状态(EH和EH2)评估,2H2O中k(cat.)的pH依赖性受pK(app.)值变化的影响,这是由于EH2状态的动力学参数k'cat.相对于EH状态的k(cat.)在2H2O中的下降不均匀,从而导致该参数的pK(app.)值在2H2O中可变偏移0.5至1.2个pH单位。在2H2O中,观察到的k(cat.)/Km(app.)的pH无关极限速率常数因对EH2状态动力学参数的影响而在0.5至1.0之间变化,k'cat./K'm相对于EH状态在0.2至0.7之间变化,k(cat.)/Km在0.4至1.0之间变化。观察到的对k(cat.)/Km(app.)的影响最终是2H2O对AcChE的EH2状态的k'cat.和K'm相对于EH状态的k(cat.)和Km的可变影响的结果。这些影响导致了pH - k(cat.)/Km曲线在2H2O中pK(app.)值的可变偏移和超过0.5个pH单位的变化。k(cat.)/Km向上弯曲的氢库存是k(cat.)线性氢库存和Km向下弯曲的结果,并非如文献中所声称的是限速底物诱导契合过程所致。(摘要截取自400字)