Department of Microbiology and Public Health and Department of Crop and Soil Sciences, Michigan State University, East Lansing, Michigan 48824.
Appl Environ Microbiol. 1986 Aug;52(2):345-51. doi: 10.1128/aem.52.2.345-351.1986.
A phenol-degrading methanogenic enrichment was successfully immobilized in agar as shown by the stoichiometric conversion of phenol to CH(4) and CO(2). The enrichment contained members of three physiological groups necessary for the syntrophic mineralization of phenol: a phenol-oxidizing bacterium, a Methanothrix-like bacterium, and an H(2)-utilizing methanogen. The immobilization technique resulted in the cells being embedded in a long, thin agar strand (1 mm in diameter by 2 to 50 cm in length) that resembled spaghetti. Immobilization had three effects as shown by a comparative kinetic analysis of phenol degradation by free versus immobilized cells. (i) The maximum rate of degradation was reduced from 14.8 to 10.0 mug of phenol per h; (ii) the apparent K(m) for the overall reaction was reduced from 90 to 46 mug of phenol per ml, probably because of the retention of acetate, H(2) and CO(2) in the proximity of immobilized methanogens; and (iii) the cells were protected from substrate inhibition caused by high concentrations of phenol, which increased the apparent K(i) value from 900 to 1,725 mug of phenol per ml. Estimates for the kinetic parameters K(m), K(i), and V(max) were used in a modified substrate inhibition model that simulated rates of phenol degradation for given phenol concentrations. The simulated rates were in close agreement with experimentally derived rates for both stimulatory and inhibitory concentrations of phenol.
成功地将苯酚降解产甲烷的富集物固定在琼脂中,如苯酚被化学计量地转化为 CH(4)和 CO(2)所示。该富集物包含了三种生理群的成员,这些成员对于苯酚的共营养矿化是必需的:一种苯酚氧化细菌、一种类似于 Methanothrix 的细菌和一种利用 H(2)的产甲烷菌。固定化技术导致细胞嵌入在长而细的琼脂链中(直径 1 毫米,长 2 到 50 厘米),类似于意大利面条。通过比较游离细胞和固定化细胞降解苯酚的动力学分析,固定化具有三个作用。(i)最大降解速率从 14.8 降至 10.0 mug/h;(ii)整个反应的表观 K(m)从 90 降至 46 mug/ml,可能是由于乙酸盐、H(2)和 CO(2)在固定化产甲烷菌附近的保留;(iii)细胞受到高浓度苯酚引起的底物抑制的保护,这使得表观 K(i)值从 900 增至 1725 mug/ml。用估计的动力学参数 K(m)、K(i)和 V(max),对一个改良的底物抑制模型进行了模拟,该模型模拟了给定苯酚浓度下苯酚降解的速率。模拟速率与苯酚的刺激和抑制浓度的实验所得速率非常吻合。