Ricci William M, Schwappach John, Tucker Michael, Coupe Kevin, Brandt Angel, Sanders Roy, Leighton Ross
Washington University School of Medicine at Barnes-Jewish Hospital, Department of Orthopaedic Surgery, St Louis, MO 63110, USA.
J Orthop Trauma. 2006 Nov-Dec;20(10):663-7. doi: 10.1097/01.bot.0000248472.53154.14.
The purpose of this study was to compare results of femoral shaft fracture treatment with nailing through the greater trochanter to nailing through the piriformis fossa with nails specifically designed for each starting point.
Prospective cohort study.
Four level 1 trauma centers.
One-hundred and eight patients treated by 1 of 4 surgeons for a femoral shaft or subtrochanteric fracture with antegrade nailing between January 2001 and April 2003 were included. Four patients who expired early in the postoperative period and 13 with insufficient follow-up were excluded from analysis.
Patients were treated with either nailing through a greater trochanter starting point with the Trigen TAN nail (GT group) (n = 38) or through a piriformis fossa starting point with the Trigen FAN nail (PF group) (n = 53).
Operative time, fluoroscopy time, fracture alignment, fracture healing, complications, and functional outcome based on the lower-extremity measure (LEM).
Thirty-seven of the 38 fractures from the GT group and 52 of the 53 fractures from the PF group healed after the index procedure. One patient from the GT group had external rotation malalignment of 12 degrees. There were no other malalignments or iatrogenic fracture comminution. There were 2 infectious complications, 1 from each group. The average operative time was 75 minutes for piriformis insertion using the FAN nail and 62 minutes for trochanteric insertion using the TAN nail (P = 0.08). The average fluoroscopy time was 61% greater for the PF group (153 seconds) than for the GT group (95 seconds) (P < 0.05). These differences were magnified in patients who were obese (body mass index > 30) where the operative time was 30% greater (P < 0.05) and the fluoroscopy time was 73% higher in the PF group (P < 0.02). Patients from both groups had a similar initial decline and subsequent improvement in function over time (P > 0.05).
A femoral nail specially designed for trochanteric insertion resulted in equally high union rates, equally low complication rates, and functional results similar to conventional antegrade femoral nailing through the piriformis fossa. The greater trochanter entry portal coupled with an appropriately designed nail represents a rational alternative for antegrade femoral nailing with the benefit of decreased fluoroscopy time and decreased operative time in patients who are obese.
本研究旨在比较使用专门为每个起始点设计的髓内钉,经大转子与经梨状窝行股骨干骨折髓内钉固定的治疗结果。
前瞻性队列研究。
四个一级创伤中心。
纳入2001年1月至2003年4月间由4位外科医生之一采用顺行髓内钉固定治疗股骨干或转子下骨折的108例患者。4例术后早期死亡患者及13例随访不足患者被排除在分析之外。
患者分别接受经大转子起始点使用Trigen TAN髓内钉(GT组)(n = 38)或经梨状窝起始点使用Trigen FAN髓内钉(PF组)(n = 53)治疗。
手术时间、透视时间、骨折对线情况、骨折愈合情况、并发症以及基于下肢测量(LEM)的功能结果。
GT组38例骨折中有37例、PF组53例骨折中有52例在初次手术后愈合。GT组1例患者存在12度的外旋畸形。无其他畸形或医源性骨折粉碎。有2例感染性并发症,每组各1例。使用FAN髓内钉经梨状窝置入的平均手术时间为75分钟,使用TAN髓内钉经转子置入的平均手术时间为62分钟(P = 0.08)。PF组的平均透视时间(153秒)比GT组(95秒)长61%(P < 0.05)。在肥胖患者(体重指数> 30)中,这些差异更为明显,其中手术时间长30%(P < 0.05),PF组的透视时间高73%(P < 0.02)。两组患者随时间推移功能均有类似的初始下降及随后改善(P > 0.05)。
专门为经转子置入设计的股骨髓内钉导致同样高的愈合率、同样低的并发症发生率,且功能结果与经梨状窝传统顺行股骨髓内钉固定相似。大转子入路联合适当设计的髓内钉是顺行股骨髓内钉固定的合理替代方法,其优点是减少肥胖患者的透视时间和手术时间。