Wan M P, Chao C Y H
Department of Mechanical Engineering, The Hong Kong University of Science and Technology, Clear Water Bay, Hong Kong.
J Biomech Eng. 2007 Jun;129(3):341-53. doi: 10.1115/1.2720911.
Expiratory droplets and droplet nuclei can be pathogen carriers for airborne diseases. Their transport characteristics were studied in detail in two idealized floor-supply-type ventilation flow patterns: Unidirectional-upward and single-side-floor, using a multiphase numerical model. The model was validated by running interferometric Mie imaging experiments using test droplets with nonvolatile content, which formed droplet nuclei, ultimately, in a class-100 clean-room chamber. By comparing the droplet dispersion and removal characteristics with data of two other ceiling-supply ventilation systems collected from a previous work, deviations from the perfectly mixed ventilation condition were found to exist in various cases to different extent. The unidirectional-upward system was found to be more efficient in removing the smallest droplet nuclei (formed from 1.5 mum droplets) by air extraction, but it became less effective for larger droplets and droplet nuclei. Instead, the single-side-floor system was shown to be more favorable in removing these large droplets and droplet nuclei. In the single-side-floor system, the lateral overall dispersion coefficients for the small droplets and nuclei (initial size </=45 mum) were about an order of magnitude higher than those in the unidirectional-upward system. It indicated that bulk lateral airflow transport in the single-side-floor system was much stronger than the lateral dispersion mechanism induced mainly by air turbulence in the unidirectional-upward system. The time required for the droplets and droplet nuclei to be transported to the exhaust vent or deposition surfaces for removal varied with different ventilation flow patterns. Possible underestimation of exposure level existed if the perfectly mixed condition was assumed. For example, the weak lateral dispersion in the unidirectional ventilation systems made expiratory droplets and droplet nuclei stay at close distance to the source leading to highly nonuniform spatial distributions. The distance between the source and susceptible patients became an additional concern in exposure analysis. Relative significance of the air-extraction removal mechanism was studied. This can have impact to the performance evaluation of filtration and disinfection systems installed in the indoor environment. These findings revealed the need for further development in a risk-assessment model incorporating the effect of different ventilation systems on distributing expiratory droplets and droplet nuclei nonuniformly in various indoor spaces, such as buildings, aircraft cabins, trains, etc.
呼气飞沫和飞沫核可能是空气传播疾病的病原体携带者。利用多相数值模型,在两种理想化的地板送风式通风流型(单向向上和单侧地板)中详细研究了它们的传输特性。该模型通过使用含有非挥发性成分的测试液滴进行干涉 Mie 成像实验进行了验证,这些测试液滴最终在 100 级洁净室内形成了飞沫核。通过将液滴扩散和去除特性与先前工作中收集的另外两种天花板送风通风系统的数据进行比较,发现不同情况下在不同程度上存在与完全混合通风条件的偏差。发现单向向上系统通过抽气去除最小的飞沫核(由 1.5 微米液滴形成)效率更高,但对较大的液滴和飞沫核效果较差。相反,单侧地板系统在去除这些大液滴和飞沫核方面表现更优。在单侧地板系统中,小液滴和核(初始尺寸≤45 微米)的横向总体扩散系数比单向向上系统中的大约高一个数量级。这表明单侧地板系统中的横向整体气流传输比单向向上系统中主要由空气湍流引起的横向扩散机制要强得多。液滴和飞沫核传输到排气口或沉积表面以进行去除所需的时间因不同的通风流型而异。如果假设为完全混合条件,可能会低估暴露水平。例如,单向通风系统中的弱横向扩散使呼气飞沫和飞沫核停留在离源很近的距离,导致空间分布高度不均匀。在暴露分析中,源与易感患者之间的距离成为另一个需要关注的问题。研究了抽气去除机制的相对重要性。这可能会影响室内环境中安装的过滤和消毒系统的性能评估。这些发现表明,需要进一步开发一种风险评估模型,该模型纳入不同通风系统对在各种室内空间(如建筑物、飞机机舱、火车等)中不均匀分布呼气飞沫和飞沫核的影响。