Everett Thomas H, Lee Ken W, Wilson Emily E, Guerra Jose M, Varosy Paul D, Olgin Jeffrey E
Cardiac Electrophysiology, Division of Cardiology, University of California, San Francisco, California 94143, USA.
J Cardiovasc Electrophysiol. 2009 Mar;20(3):325-35. doi: 10.1111/j.1540-8167.2008.01305.x. Epub 2008 Sep 17.
Different technologies have been developed for radiofrequency ablation (RFA), which include increasing electrode (tip) size and cooling the tip through irrigation either internally (closed-loop) with D5W or externally (open-loop) with saline. Although these catheters are widely used clinically, the propensity for adverse events and the lesion profiles of each of these catheter technologies have not been directly compared under a wide range of controlled conditions.
Freshly excised canine thigh muscle was placed in a chamber filled with circulating, heparinized blood heated to 37 degrees C. Five different catheters were tested: 4 mm tip, 10 mm tip single thermistor, 10 mm tip multitemperature sensor, 4 mm closed-loop irrigated cooled-tip, and 4 mm open-loop irrigated cooled tip at several different contact and power settings. The catheter and tissue interface was continuously monitored with intracardiac echocardiography (echo) (Acuson). During the RFA, any bubbling generated from the tip and/or popping seen on echo was noted, and after each RFA, the catheter and lesion were examined for the presence of thrombus. For all of the catheters, complications correlated to the electrode tip temperature and power setting. All of the catheters experienced complications at any lesion size except for the open-irrigated catheter, which only had complications at the largest lesions. Overall, the cooled tip catheters experienced an at least sixfold greater odds of popping, bubbling, and impedance rises than the 4 mm, but the majority occurred at power levels greater than 20 W. The open-irrigated catheters created eccentric lesions that extended away from the tissue-catheter interface, in the direction of blood flow. In addition, it produced saline filled blisters at the lesion site in 16.7% of the burns. The 10 mm catheter had an at least twofold greater odds of thrombus, charring, and bubbling, but larger lesions than the 10 mm multitemperature sensor catheter.
Catheter type, contact conditions, and power settings all play a role in lesion size and in the frequency of complications that occur during an RFA. Cooling the electrode tip, either internally or externally, does not prevent complications from occurring, especially at the higher power control settings. Adding more temperature sensors to the 10 mm seems to reduce the amount of complications that can occur.
已经开发出不同的射频消融(RFA)技术,包括增大电极(尖端)尺寸以及通过用5%葡萄糖水溶液进行内部(闭环)或用盐水进行外部(开环)冲洗来冷却尖端。尽管这些导管在临床上广泛使用,但在广泛的受控条件下,尚未直接比较这些导管技术中每种技术的不良事件倾向和损伤情况。
将新鲜切除的犬大腿肌肉置于充满循环的、肝素化的、加热至37摄氏度血液的腔室中。测试了五种不同的导管:4毫米尖端、10毫米尖端单热敏电阻、1毫米尖端多温度传感器、4毫米闭环冲洗冷却尖端以及4毫米开环冲洗冷却尖端,在几种不同的接触和功率设置下进行测试。通过心内超声心动图(回声)(Acuson)连续监测导管与组织的界面。在RFA期间,记录从尖端产生的任何气泡和/或在回声上看到的爆裂,并且在每次RFA之后,检查导管和损伤部位是否存在血栓。对于所有导管,并发症与电极尖端温度和功率设置相关。除了开环冲洗导管仅在最大损伤时出现并发症外,所有导管在任何损伤尺寸下均出现并发症。总体而言,冷却尖端导管出现爆裂、气泡和阻抗升高的几率至少比4毫米导管高六倍,但大多数发生在功率水平大于20瓦时。开环冲洗导管产生偏心损伤,该损伤从组织 - 导管界面沿血流方向延伸。此外,在16.7%的烧伤中,它在损伤部位产生充满盐水的水泡。10毫米导管出现血栓、炭化和气泡的几率至少比10毫米多温度传感器导管高两倍,但损伤比其大。
导管类型、接触条件和功率设置在RFA期间发生的损伤大小和并发症频率中均起作用。内部或外部冷却电极尖端并不能防止并发症的发生,尤其是在较高功率控制设置下。在10毫米导管上增加更多温度传感器似乎可以减少可能发生的并发症数量。