Langner U W, Keall P J
Department of Radiation Oncology, Radiation Physics Division, Stanford University Cancer Center, 875 Blake Wilbur Drive, Stanford, California 94305-5847, USA.
Med Phys. 2008 Oct;35(10):4501-12. doi: 10.1118/1.2977539.
Four dimensional (4D) computed tomography (CT) image sorting is currently a retrospective procedure. Mismatches in displacement and/or phase of a patient's respiratory signal, corresponding with two dimensional images taken at subsequent couch positions, become visible as artifacts in reconstructed 4D CT images. These artifacts appear as undefined or irregular boundaries in the 4D CT images and cause systematic errors in patient contouring and dose calculations. In addition, the substantially higher dose required for 4D CT, compared with 3D CT, is of concern. To minimize these problems, we developed a prospective respiratory displacement and velocity based cine 4D CT (PDV CT) method to trigger image acquisition if the displacement and velocity of the respiratory signal occurred within predetermined tolerances simultaneously. The use of velocity avoids real-time phase estimation. Real-time image acquisition ensures data sufficiency, while avoiding the need for redundant data. This may potentially result in a lower dose to the patient. PDV CT was compared with retrospective 4D CT acquisition methods, using respiratory signals of 24 lung cancer patients (103 sessions) under free breathing conditions. Image acquisition was simulated for each of these sessions from the respiratory signal. The root mean square (RMS) of differences between displacements and velocities of the respiratory signal corresponding to subsequent images was calculated in order to evaluate the image-sorting accuracy of each method. Patient dose reductions of 22 to 50% were achieved during image acquisition depending on the model parameters chosen. The mean RMS differences over all sessions and image bins show that PDV CT produces similar results to retrospective displacement sorting overall, although improvements of the RMS difference up to 20% were achieved depending on the model parameters chosen. Velocity RMS differences improved between 30 and 45% when compared with retrospective phase sorting. The efficiency in acquisition compared with retrospective phase sorting varied from approximately 10% for displacement and velocity tolerances of 1 mm and 4 mm/s, respectively, to 80 to 93% for 4 mm and 4 mm/s. The lower variation in the displacement and velocity of the respiratory signal in each image bin indicates that PDV CT could be a valuable tool for reducing artifacts in 4D CT images and lowering patient dose, although the cost may be increased acquisition time.
四维(4D)计算机断层扫描(CT)图像排序目前是一种回顾性程序。患者呼吸信号的位移和/或相位与在后续治疗床位置拍摄的二维图像不匹配,在重建的4D CT图像中表现为伪影。这些伪影在4D CT图像中表现为不明确或不规则的边界,并在患者轮廓勾画和剂量计算中导致系统误差。此外,与3D CT相比,4D CT所需的剂量显著更高,这令人担忧。为了尽量减少这些问题,我们开发了一种基于前瞻性呼吸位移和速度的动态4D CT(PDV CT)方法,以便在呼吸信号的位移和速度同时出现在预定容差范围内时触发图像采集。使用速度避免了实时相位估计。实时图像采集确保了数据充足性,同时避免了对冗余数据的需求。这可能会降低患者的剂量。在自由呼吸条件下,使用24名肺癌患者(103次扫描)的呼吸信号,将PDV CT与回顾性4D CT采集方法进行了比较。针对这些扫描中的每一次,根据呼吸信号模拟图像采集。计算了与后续图像对应的呼吸信号位移和速度之间差异的均方根(RMS),以评估每种方法的图像排序准确性。根据所选的模型参数,在图像采集期间患者剂量降低了22%至50%。所有扫描和图像区间的平均RMS差异表明,总体而言,PDV CT产生的结果与回顾性位移排序相似,尽管根据所选的模型参数,RMS差异提高了20%。与回顾性相位排序相比,速度RMS差异提高了30%至45%。与回顾性相位排序相比,采集效率分别从位移和速度容差为1 mm和4 mm/s时的约10%变化到4 mm和4 mm/s时的80%至93%。每个图像区间内呼吸信号位移和速度的较低变化表明,PDV CT可能是减少4D CT图像伪影和降低患者剂量的有价值工具,尽管代价可能是采集时间增加。