Flaibani Marina, Luni Camilla, Sbalchiero Elisa, Elvassore Nicola
Dept. of Chemical Engineering, University of Padova, I-35131 Padova, Italy.
Biotechnol Prog. 2009 Jan-Feb;25(1):286-95. doi: 10.1002/btpr.40.
It has been widely demonstrated that perfusion bioreactors improve in vitro three-dimensional (3D) cultures in terms of high cell density and uniformity of cell distribution; however, the studies reported in literature were primarily based on qualitative analysis (histology, immunofluorescent staining) or on quantitative data averaged on the whole population (DNA assay, PCR). Studies on the behavior, in terms of cell cycle, of a cell population growing in 3D scaffolds in static or dynamic conditions are still absent. In this work, a perfusion bioreactor suitable to culture C(2)C(12) muscle precursor cells within 3D porous collagen scaffolds was designed and developed and a method based on flowcytometric analyses for analyzing the cell cycle in the cell population was established. Cells were extracted by enzymatic digestion of the collagen scaffolds after 4, 7, and 10 days of culture, and flow cytometric live/dead and cell cycle analyses were performed with Propidium Iodide. A live/dead assay was used for validating the method for cell extraction and staining. Moreover, to investigate spatial heterogeneity of the cell population under perfusion conditions, two stacked scaffolds in the 3D domain, of which only the upstream layer was seeded, were analyzed separately. All results were compared with those obtained from static 3D cultures. The live/dead assay revealed the presence of less than 20% of dead cells, which did not affect the cell cycle analysis. Cell cycle analyses highlighted the increment of cell fractions in proliferating phases (S/G(2)/M) owing to medium perfusion in long-term cultures. After 7-10 days, the percentage of proliferating cells was 8-12% for dynamic cultures and 3-5% for the static controls. A higher fraction of proliferating cells was detected in the downstream scaffold. From a general perspective, this method provided data with a small standard deviation and detected the differences between static and dynamic cultures and between upper and lower scaffolds. Our methodology can be extended to other cell types to investigate the influence of 3D culture conditions on the expression of other relevant cell markers.
大量研究表明,灌注生物反应器在提高体外三维(3D)培养的细胞密度和细胞分布均匀性方面具有显著效果;然而,文献报道的研究主要基于定性分析(组织学、免疫荧光染色)或对整个群体的平均定量数据(DNA检测、PCR)。目前仍缺乏关于在静态或动态条件下,细胞群体在3D支架中生长时细胞周期行为的研究。在本研究中,设计并开发了一种适用于在3D多孔胶原支架内培养C2C12肌肉前体细胞的灌注生物反应器,并建立了一种基于流式细胞术分析细胞群体细胞周期的方法。培养4、7和10天后,通过酶消化胶原支架提取细胞,并用碘化丙啶进行流式细胞术活/死和细胞周期分析。采用活/死检测法验证细胞提取和染色方法。此外,为了研究灌注条件下细胞群体的空间异质性,对3D区域中两个堆叠的支架进行了单独分析,其中仅在上游层接种细胞。所有结果均与静态3D培养获得的结果进行比较。活/死检测显示死细胞比例低于20%,这对细胞周期分析没有影响。细胞周期分析表明,由于长期培养中的培养基灌注,增殖期(S/G2/M)的细胞比例增加。7-10天后,动态培养的增殖细胞百分比为8-12%,静态对照为3-5%。在下游支架中检测到更高比例的增殖细胞。总体而言,该方法提供的数据标准差较小,能够检测到静态和动态培养之间以及上下支架之间的差异。我们的方法可以扩展到其他细胞类型,以研究3D培养条件对其他相关细胞标志物表达的影响。