Radisic Milica, Euloth Michelle, Yang Liming, Langer Robert, Freed Lisa E, Vunjak-Novakovic Gordana
Department of Chemical Engineering, Massachusetts Institute of Technology, Cambridge, Massachusetts, USA.
Biotechnol Bioeng. 2003 May 20;82(4):403-14. doi: 10.1002/bit.10594.
Tissue engineering of 1- to 5-mm-thick, functional constructs based on cells that cannot tolerate hypoxia for prolonged time periods (e.g., cardiac myocytes) critically depends on our ability to seed the cells at a high and spatially uniform initial density and to maintain their viability and function. We hypothesized that rapid gel-cell inoculation in conjunction with direct medium perfusion through the seeded scaffold would increase the rate, yield, viability, and uniformity of cell seeding. Two cell types were studied: neonatal rat cardiomyocytes for feasibility studies of seeding and cultivation with direct medium perfusion, and C2C12 cells (a murine myoblast cell line) for detailed seeding studies. Cells were seeded at densities corresponding to those normally present in the adult rat heart ([0.5-1] x 10(8) cells/cm(3)), into collagen sponges (13 mm x 3 mm discs), using Matrigel as a vehicle for rapid cell delivery. Scaffolds inoculated with cell-gel suspension were seeded either in perfused cartridges with alternating medium flow or in orbitally mixed Petri dishes. The effects of seeding time (1.5 or 4.5 h), initial cell number (6 or 12 million cells per scaffold), and seeding set-up (medium perfusion at 0.5 and 1.5 mL/min; orbitally mixed dishes) were investigated using a randomized three-factor factorial experimental design with two or three levels and three replicates. The seeding cell yield was consistently high (over 80%), and it appeared to be determined by the rapid gel inoculation. The decrease in cell viability was markedly lower for perfused cartridges than for orbitally mixed dishes (e.g., 8.8 +/- 0.8% and 56.3 +/- 4%, respectively, for 12 million cells at 4.5 h post-seeding). Spatially uniform cell distributions were observed in perfused constructs, whereas cells were mainly located within a thin (100-200 microm) surface layer in dish seeded constructs. Over 7 days of cultivation, medium perfusion maintained the viability and differentiated function of cardiac myocytes, and the constructs contracted synchronously in response to electrical stimulation. Direct perfusion can thus enable seeding of hypoxia-sensitive cells at physiologically high and spatially uniform initial densities and maintain cell viability and function.
基于不能长时间耐受缺氧的细胞(如心肌细胞)构建1至5毫米厚的功能性组织工程构建体,关键取决于我们以高且空间均匀的初始密度接种细胞并维持其活力和功能的能力。我们假设,快速凝胶-细胞接种结合通过接种支架的直接培养基灌注,将提高细胞接种的速率、产量、活力和均匀性。研究了两种细胞类型:用于接种和直接培养基灌注培养可行性研究的新生大鼠心肌细胞,以及用于详细接种研究的C2C12细胞(一种小鼠成肌细胞系)。使用基质胶作为快速细胞递送载体,将细胞以与成年大鼠心脏中正常存在的密度([0.5 - 1]×10⁸个细胞/cm³)相对应的密度接种到胶原海绵(13毫米×3毫米圆盘)中。接种有细胞-凝胶悬浮液的支架,要么接种到具有交替培养基流的灌注盒中,要么接种到轨道混合培养皿中。使用具有两个或三个水平和三个重复的随机三因素析因实验设计,研究接种时间(1.5或4.5小时)、初始细胞数量(每个支架6或1200万个细胞)和接种设置(0.5和1.5毫升/分钟的培养基灌注;轨道混合培养皿)的影响。接种细胞产量始终很高(超过80%),这似乎由快速凝胶接种决定。灌注盒中细胞活力的降低明显低于轨道混合培养皿(例如,接种后4.5小时,1200万个细胞时分别为8.8±0.8%和56.3±4%)。在灌注构建体中观察到空间均匀的细胞分布,而在培养皿接种构建体中细胞主要位于薄(100 - 200微米)表层内。在7天的培养过程中,培养基灌注维持了心肌细胞的活力和分化功能,并且构建体在电刺激下同步收缩。因此,直接灌注能够以生理上高且空间均匀的初始密度接种对缺氧敏感的细胞,并维持细胞活力和功能。