Suppr超能文献

优化和验证放射性核素血管造影相位分析参数,以定量评估机械不同步。

Optimization and validation of radionuclide angiography phase analysis parameters for quantification of mechanical dyssynchrony.

机构信息

Division of Nuclear Medicine, The Ottawa Hospital, Ottawa, ON, K1Y 4E9, Canada.

出版信息

J Nucl Cardiol. 2009 Nov-Dec;16(6):895-903. doi: 10.1007/s12350-009-9119-4. Epub 2009 Jul 22.

Abstract

INTRODUCTION

Cardiac resynchronization therapy (CRT) has the potential to improve the outcome of patients suffering from mechanical dyssynchrony and heart failure. It has been suggested that accurate quantification of baseline extent of mechanical dyssynchrony may lead to pre-selection of patients likely to respond to CRT. The standard deviation from a phase histogram (phaseSD), synchrony (S) and entropy (E) are parameters obtained from phase analysis of planar radionuclide angiography (RNA) that may provide an accurate means of assessing mechanical dyssynchrony. In this paper, the ability of phaseSD, S, and E to detect mechanical dyssynchrony was investigated and optimal values for image smoothing, histogram noise thresholding, and bin size were defined. Finally, the intra- and inter-observer reproducibility of the methodology was assessed.

METHODS

PhaseSD, S, and E were calculated for 37 normal subjects (LVEF > 50%, end-diastolic volume < 120 mL, end-systolic volume < 60 mL, QRS < 120 ms, and normal wall motion) and 53 patients with mechanical dyssynchrony (LVEF < 30%, QRS > 120 ms, and typical LBBB). Receiver-operator characteristics (ROC) curves were created and the area under the curve (AUC), for each parameter, was determined using three different imaging filters (no filter and an order 5 Hann filter with cut-off of 5/50 and 10/50). The AUC was also determined using histogram threshold values varying between 0% and 50% (of the max amplitude value). Finally, AUC for E was determined for bins sizes varying between 1 degrees and 20 degrees . Inter- and intra-observer variability was calculated at optimal imaging values.

RESULTS

No smoothing was found to maximize the AUC. The AUC was independent of histogram threshold value. However, a value of 20% provided optimal visualization of the phase image. The AUC was also independent of bin size. At the optimal imaging values, the sensitivity and specificity for all parameters for detection of mechanical dyssynchrony was measured to be 89-100%. Inter- and intra-observer correlation coefficients >0.99 were found for phaseSD, S and E.

CONCLUSIONS

Optimized planar RNA phase analysis parameters, phaseSD, S, and E, were able to detect mechanical dyssynchrony with low inter- and intra-observer variability. Studies assessing the ability of these parameters to predict CRT outcome are required.

摘要

简介

心脏再同步治疗(CRT)有可能改善机械不同步和心力衰竭患者的预后。有人提出,准确量化基线机械不同步的程度可能会导致预先选择可能对 CRT 有反应的患者。相位直方图的标准差(phaseSD)、同步性(S)和熵(E)是从平面放射性核素血管造影术(RNA)相位分析中获得的参数,它们可能提供评估机械不同步的准确方法。在本文中,研究了 phaseSD、S 和 E 检测机械不同步的能力,并确定了图像平滑、直方图噪声阈值和 bin 大小的最佳值。最后,评估了该方法的观察者内和观察者间的可重复性。

方法

为 37 名正常受试者(LVEF > 50%,舒张末期容积<120mL,收缩末期容积<60mL,QRS<120ms,正常壁运动)和 53 名机械不同步患者(LVEF<30%,QRS>120ms,典型 LBBB)计算了 phaseSD、S 和 E。创建了接收器操作特性(ROC)曲线,并使用三种不同的成像滤波器(无滤波器和截止值为 5/50 和 10/50 的 5 阶 Hann 滤波器)确定每个参数的曲线下面积(AUC)。还使用在 0%到 50%(最大幅度值)之间变化的直方图阈值值确定了 AUC。最后,还确定了 E 的 AUC 对于在 1 度到 20 度之间变化的 bin 大小。在最佳成像值下计算了观察者内和观察者间的可变性。

结果

未发现平滑可最大化 AUC。AUC 与直方图阈值值无关。然而,20%的值为相位图像的最佳可视化提供了最佳效果。AUC 也与 bin 大小无关。在最佳成像值下,所有参数检测机械不同步的灵敏度和特异性均为 89-100%。phaseSD、S 和 E 的观察者内和观察者间相关系数>0.99。

结论

经过优化的平面 RNA 相位分析参数 phaseSD、S 和 E 能够以低观察者内和观察者间的变异性检测机械不同步。需要研究这些参数预测 CRT 结果的能力。

文献检索

告别复杂PubMed语法,用中文像聊天一样搜索,搜遍4000万医学文献。AI智能推荐,让科研检索更轻松。

立即免费搜索

文件翻译

保留排版,准确专业,支持PDF/Word/PPT等文件格式,支持 12+语言互译。

免费翻译文档

深度研究

AI帮你快速写综述,25分钟生成高质量综述,智能提取关键信息,辅助科研写作。

立即免费体验