Suppr超能文献

无线 iButton 和热敏电阻器用于人体皮肤温度测量的有效性。

The validity of wireless iButtons and thermistors for human skin temperature measurement.

机构信息

Extremes Research Group, Bangor University, Bangor LL572PZ, UK.

出版信息

Physiol Meas. 2010 Jan;31(1):95-114. doi: 10.1088/0967-3334/31/1/007. Epub 2009 Nov 26.

Abstract

Skin temperature is a fundamental variable in human thermo-physiology, and yet skin temperature measurement remains impractical in most free-living, exercise and clinical settings, using currently available hard-wired methods. The purpose of this study was to compare wireless iButtons and hard-wired thermistors for human skin temperature measurement. In the first of two investigations, iButtons and thermistors monitored temperature in a controlled water bath (range: 10-40 degrees C) and were referenced against a certified, mercury thermometer. In the second investigation, eight healthy males completed three randomized trials (ambient temperature = 10 degrees C, 20 degrees C and 30 degrees C) while both devices recorded skin temperature at rest (in low and high wind velocities) and during cycle-ergometry exercise. The results are as follows. Investigation 1: both devices displayed very high validity correlation with the reference thermometer (r > 0.999). Prior to correction, the mean bias was +0.121 degrees C for iButtons and +0.045 degrees C for thermistors. Upon calibration correction the mean bias for iButtons and thermistors was not significantly different from zero bias. Interestingly, a typical error of the estimate of iButtons (0.043 degrees C) was 1.5 times less than that of thermistors (0.062 degrees C), demonstrating iButtons' lower random error. Investigation 2: the offset between iButton and thermistor readings was generally consistent across conditions; however, thermistor responses gave readings that were always closer to ambient temperature than those given by iButtons, suggesting potential thermistor drift towards environmental conditions. Mean temperature differences between iButtons and thermistors during resting trials ranged from 0.261 degrees C to 1.356 degrees C. Mean temperature differences between iButtons and thermistors during exercise were 0.989 degrees C (ambient temperature = 10 degrees C), 0.415 degrees C (ambient temperature = 20 degrees C) and 0.318 degrees C (ambient temperature = 30 degrees C). Observed error estimates were within the acceptable limits for the skin temperature method comparison, with typical errors <0.3 degrees C, correlation coefficients >0.9 and CV <1% under all conditions. These findings indicate that wireless iButtons provide a valid alternative for human skin temperature measurement during laboratory and field investigations particularly when skin temperature measurement using other currently available methods may prove problematic.

摘要

皮肤温度是人体热生理学中的一个基本变量,但使用当前可用的有线方法,在大多数自由生活、运动和临床环境中,皮肤温度测量仍然不切实际。本研究的目的是比较无线 iButton 和有线热敏电阻器在人体皮肤温度测量中的应用。在两项研究中的第一项中,iButton 和热敏电阻器在受控水浴(范围:10-40°C)中监测温度,并与经过认证的水银温度计进行参考比较。在第二项研究中,八名健康男性在三种随机试验(环境温度=10°C、20°C 和 30°C)中完成,同时两种设备在休息时(低风和高风速)和进行循环测功运动时记录皮肤温度。结果如下。研究 1:两种设备与参考温度计的相关性非常高(r>0.999)。在未校正之前,iButton 的平均偏差为+0.121°C,热敏电阻器的平均偏差为+0.045°C。经过校准校正后,iButton 和热敏电阻器的平均偏差与零偏差没有显著差异。有趣的是,iButton 的典型估计误差(0.043°C)是热敏电阻器(0.062°C)的 1.5 倍,表明 iButton 的随机误差较低。研究 2:在不同条件下,iButton 和热敏电阻器之间的读数差值通常保持一致;然而,热敏电阻器的响应总是比 iButton 更接近环境温度,这表明热敏电阻器可能向环境条件漂移。在休息试验中,iButton 和热敏电阻器之间的平均温度差异范围为 0.261°C 至 1.356°C。在运动试验中,iButton 和热敏电阻器之间的平均温度差异为 0.989°C(环境温度=10°C)、0.415°C(环境温度=20°C)和 0.318°C(环境温度=30°C)。观察到的误差估计值在皮肤温度方法比较的可接受范围内,所有条件下的典型误差<0.3°C、相关系数>0.9 和 CV<1%。这些发现表明,无线 iButton 在实验室和现场调查中为人体皮肤温度测量提供了一种有效的替代方法,特别是在使用其他当前可用方法可能存在问题时。

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验