Identification of rupture locations in patient-specific abdominal aortic aneurysms using experimental and computational techniques.

In the event of abdominal aortic aneurysm (AAA) rupture, the outcome is often death. This paper aims to experimentally identify the rupture locations of in vitro AAA models and validate these rupture sites using finite element analysis (FEA). Silicone rubber AAA models were manufactured using two different materials (Sylgard 160 and Sylgard 170, Dow Corning) and imaged using computed tomography (CT). Experimental models were inflated until rupture with high speed photography used to capture the site of rupture. 3D reconstructions from CT scans and subsequent FEA of these models enabled the wall stress and wall thickness to be determined for each of the geometries. Experimental models ruptured at regions of inflection, not at regions of maximum diameter. Rupture pressures (mean+/-SD) for the Sylgard 160 and Sylgard 170 models were 650.6+/-195.1mmHg and 410.7+/-159.9mmHg, respectively. Computational models accurately predicted the locations of rupture. Peak wall stress for the Sylgard 160 and Sylgard 170 models was 2.15+/-0.26MPa at an internal pressure of 650mmHg and 1.69+/-0.38MPa at an internal pressure of 410mmHg, respectively. Mean wall thickness of all models was 2.19+/-0.40mm, with a mean wall thickness at the location of rupture of 1.85+/-0.33 and 1.71+/-0.29mm for the Sylgard 160 and Sylgard 170 materials, respectively. Rupture occurred at the location of peak stress in 80% (16/20) of cases and at high stress regions but not peak stress in 10% (2/20) of cases. 10% (2/20) of models had defects in the AAA wall which moved the rupture location away from regions of elevated stress. The results presented may further contribute to the understanding of AAA biomechanics and ultimately AAA rupture prediction.