Department of Chemical and Biochemical Engineering, Zhejiang University, Hangzhou 310027, PR China.
Bioresour Technol. 2010 Sep;101(17):6797-804. doi: 10.1016/j.biortech.2010.03.120. Epub 2010 Apr 24.
To increase the lipid productivity and thus to reduce the production cost of microalgal biodiesel, effects of cultivation conditions including KNO(3)-level, CO(2) concentration and irradiance on the cell growth, chlorophyll a content and lipid accumulation of Chlorella vulgaris were systematically investigated in a membrane sparged photobioreactor. The biochemical compositions including carbohydrates, proteins and lipids were analyzed simultaneously by the FT-IR spectroscopy. The results showed that the largest biomass productivity and the highest lipid content were obtained at different cultivation conditions. The algae should be harvested at a point that optimized the biomass productivity and lipid content. When the cultivation conditions were controlled at 1.0mM KNO(3), 1.0% CO(2) and 60 micromol photons m(-2)s(-1) at 25 degrees C, the highest lipid productivity obtained was 40 mg L(-1)d(-1), which was about 2.5-fold that had been reported by Illman et al. (2000). The influences of cultivation conditions on the cell growth, lipid accumulation, and other biochemical compositions of cells were further discussed and illustrated by a schematic which was also useful for other microalgal species.
为了提高微藻生物柴油的产油率,从而降低生产成本,本研究在膜式喷射光生物反应器中系统地考察了培养条件(包括硝酸钾浓度、二氧化碳浓度和光照强度)对普通小球藻细胞生长、叶绿素 a 含量和油脂积累的影响。利用傅里叶变换红外光谱(FT-IR)同时分析了生物量组成(碳水化合物、蛋白质和油脂)。结果表明,不同的培养条件下会得到最大的生物量生产力和最高的油脂含量。因此,应该在优化生物量生产力和油脂含量的点收获藻类。当培养条件控制在 1.0mM 硝酸钾、1.0%二氧化碳和 25℃下 60 微摩尔光子 m(-2)s(-1)时,获得的最高油脂生产力为 40mgL(-1)d(-1),约为 Illman 等人(2000 年)报道的 2.5 倍。通过示意图进一步讨论和说明了培养条件对细胞生长、油脂积累和其他细胞生化组成的影响,该示意图对其他微藻物种也具有参考价值。