Division of Histochemistry & Reproductive Toxicology, National Institute of Occupational Health (ICMR), Meghani Nagar, 380016, Ahmedabad, India,
Environ Health Prev Med. 2003 May;8(2):64-7. doi: 10.1007/BF02897929.
Welders are exposed to intense heat, toxic metals and their oxides and toxic gases during welding, and some of these substances reported to have adverse effects on reproductive organs. Thus, the present study was planned to investigate the sperm quality as well as reproductive hormones among welders exposed to a complex mixture of pollutants.
Seventeen welders aged 43.8±12.0 (mean±SD) years with welding exposure of 1 to 10 years or more participated in this study. They were performing are and gas welding in a workshop. Blood (5-6 ml) and semen samples by masturbation were collected from them. Serum was separated and analyzed for reproductive hormones by RIA techniques. Semen was processed for microscopic examination.
The results of this study indicated that sperm concentration was in the normal range (≥20 million/ml) in all seventeen welders, however, motility, morphology as well as Hypo Osmotic Swelling test (HOS) demonstrated impairment in few welders, indicating deterioration in sperm quality compared to the reported normal reference value. Compared with the normal value of hormones provided in diagnostic kits brochure, follicle stimulating hormone (FSH), leutinizing hormone (LH) and testosterone levels were in the normal range, except in two subjects who showed higher FSH and LH levels and one who showed a lower value of testosterone.
This study suggests that welding might have had some adverse effects on sperm motility, morphology and physiologic function even though sperm concentration was in the normal range. Hormonal changes did not show any definite pattern, indicating a need for further study.
焊工在焊接过程中会接触到强烈的热量、有毒金属及其氧化物和有毒气体,其中一些物质据报道对生殖器官有不良影响。因此,本研究旨在调查接触复杂污染物混合物的焊工的精子质量和生殖激素。
17 名年龄为 43.8±12.0(平均值±标准差)岁、焊接暴露时间为 1 至 10 年或更长时间的焊工参加了这项研究。他们在车间进行电弧焊和气体焊接。从他们那里采集 5-6 毫升的血液(通过手淫)和精液样本。分离血清并通过 RIA 技术分析生殖激素。处理精液进行显微镜检查。
这项研究的结果表明,所有 17 名焊工的精子浓度均在正常范围内(≥2000 万/ml),然而,运动能力、形态以及低渗肿胀试验(HOS)在少数焊工中显示出受损,表明与报告的正常参考值相比,精子质量恶化。与诊断试剂盒小册子中提供的激素正常值相比,卵泡刺激素(FSH)、促黄体生成素(LH)和睾酮水平均在正常范围内,除了两名 FSH 和 LH 水平较高的受试者和一名睾酮水平较低的受试者。
这项研究表明,尽管精子浓度在正常范围内,但焊接可能对精子运动能力、形态和生理功能产生了一些不良影响。激素变化没有显示出任何明确的模式,表明需要进一步研究。