Department of Chemistry, University of Houston, 4800 Calhoun Road, Houston, Texas 77204-5003, USA.
J Phys Chem B. 2013 Aug 29;117(34):9882-94. doi: 10.1021/jp4015096. Epub 2013 Aug 16.
The adsorption of the cationic surfactant benzyldimethylhexadecylammonium (BDMHA(+)) chloride was studied at an octadecyltrichlorosilane (OTS)-monolayer-modified silica-water interface by Raman spectroscopy in total internal reflection (TIR) geometry. The present study demonstrates the capabilities of this spectroscopic technique to evaluate thermodynamic and kinetic BDMHA(+)Cl(-) adsorption properties at the hydrophobic silica surface. The surface coverage of BDMHA(+) decreased by 50% at the hydrophobic OTS-silica surface relative to the surface coverage on bare silica; the dominating driving mechanisms for surfactant adsorption were identified as hydrophobic effects and head group charge screening by the electrolyte counterions. Addition of magnesium metal salt (MgCl2) to the aqueous solution (∼ neutral pH) lowered the surface coverage and moderately increased the Langmuir adsorption constants relative to those of the pure surfactant. These trends were previously observed at the hydrophilic, negatively charged silica surface but with a smaller change in the Gibbs free energy of adsorption at the hydrophobic silica surface. The hydrophobic OTS-silica surface properties resulted in shorter times for the surfactant to reach steady-state adsorption conditions compared to the slow adsorption kinetics previously seen with the surfactant at the hydrophilic surface. Adsorption isotherms, based on Raman signal intensities from spectral analysis, were developed according to the Langmuir adsorption model for the pure surfactant at the OTS-silica-water interface; the modified Langmuir model was applied to the surfactant adsorption in the presence of 5, 10, 50, and 100 mM magnesium chloride. Spectral analysis of the Raman scattering intensities and geometric considerations suggests a hemimicelle-type surface aggregate as the most likely surfactant structure at the OTS-silica surface. The different kinetics observed at the hydrophilic versus the hydrophobic silica surface further indicate that the surface charge and potential influence the surfactant diffusion and kinetic rates of adsorption at the silica-water interface.
十六烷基三氯硅烷(OTS)单层修饰的二氧化硅-水界面上,通过总内反射(TIR)几何拉曼光谱研究了阳离子表面活性剂苄基二甲基十六烷基氯化铵(BDMHA(+)) 氯化物的吸附。本研究证明了该光谱技术在评估疏水二氧化硅表面上热力学和动力学 BDMHA(+)Cl(-) 吸附性质方面的能力。与 bare silica 相比,BDMHA(+)在疏水 OTS-硅烷表面上的表面覆盖率降低了 50%;表面活性剂吸附的主要驱动机制被确定为疏水效应和电解质反离子对头基团电荷的屏蔽。在水溶液中添加镁金属盐(MgCl2)(~中性 pH)降低了表面覆盖率,并适度增加了 Langmuir 吸附常数,相对于纯表面活性剂而言。这些趋势以前在亲水、带负电荷的二氧化硅表面上观察到,但在疏水二氧化硅表面上吸附的吉布斯自由能变化较小。疏水 OTS-硅烷表面性质导致表面活性剂达到稳态吸附条件的时间比在亲水表面上观察到的表面活性剂的缓慢吸附动力学更短。根据拉曼信号强度的光谱分析,建立了纯表面活性剂在 OTS-硅烷-水界面上的吸附等温线,根据 Langmuir 吸附模型;在存在 5、10、50 和 100 mM 氯化镁的情况下,将改进的 Langmuir 模型应用于表面活性剂的吸附。拉曼散射强度的光谱分析和几何考虑表明,在 OTS-硅烷表面上,最有可能的表面活性剂结构是半胶束型表面聚集体。在亲水和疏水二氧化硅表面上观察到的不同动力学进一步表明,表面电荷和电位会影响表面活性剂在二氧化硅-水界面上的扩散和吸附动力学速率。