School of Clinical Sciences, Queensland University of Technology, Kelvin Grove, 4059 Queensland, Australia.
BMC Musculoskelet Disord. 2013 Aug 21;14:249. doi: 10.1186/1471-2474-14-249.
Despite the emerging use of treadmills integrated with pressure platforms as outcome tools in both clinical and research settings, published evidence regarding the measurement properties of these new systems is limited. This study evaluated the within- and between-day repeatability of spatial, temporal and vertical ground reaction force parameters measured by a treadmill system instrumented with a capacitance-based pressure platform.
Thirty three healthy adults (mean age, 21.5 ± 2.8 years; height, 168.4 ± 9.9 cm; and mass, 67.8 ± 18.6 kg), walked barefoot on a treadmill system (FDM-THM-S, Zebris Medical GmbH) on three separate occasions. For each testing session, participants set their preferred pace but were blinded to treadmill speed. Spatial (foot rotation, step width, stride and step length), temporal (stride and step times, duration of stance, swing and single and double support) and peak vertical ground reaction force variables were collected over a 30-second capture period, equating to an average of 52 ± 5 steps of steady-state walking. Testing was repeated one week following the initial trial and again, for a third time, 20 minutes later. Repeated measures ANOVAs within a generalized linear modelling framework were used to assess between-session differences in gait parameters. Agreement between gait parameters measured within the same day (session 2 and 3) and between days (session 1 and 2; 1 and 3) were evaluated using the 95% repeatability coefficient.
There were statistically significant differences in the majority (14/16) of temporal, spatial and kinetic gait parameters over the three test sessions (P < .01). The minimum change that could be detected with 95% confidence ranged between 3% and 17% for temporal parameters, 14% and 33% for spatial parameters, and 4% and 20% for kinetic parameters between days. Within-day repeatability was similar to that observed between days. Temporal and kinetic gait parameters were typically more consistent than spatial parameters. The 95% repeatability coefficient for vertical force peaks ranged between ± 53 and ± 63 N.
The limits of agreement in spatial parameters and ground reaction forces for the treadmill system encompass previously reported changes with neuromuscular pathology and footwear interventions. These findings provide clinicians and researchers with an indication of the repeatability and sensitivity of the Zebris treadmill system to detect changes in common spatiotemporal gait parameters and vertical ground reaction forces.
尽管在临床和研究环境中,集成压力平台的跑步机作为结果工具的使用越来越多,但关于这些新系统测量特性的已发表证据有限。本研究评估了一种带有电容式压力平台的跑步机系统测量的空间、时间和垂直地面反力参数的日内和日间重复性。
33 名健康成年人(平均年龄 21.5±2.8 岁;身高 168.4±9.9cm;体重 67.8±18.6kg)分别在 3 次单独测试中赤脚在跑步机系统(Zebris Medical GmbH 的 FDM-THM-S)上行走。对于每次测试,参与者都设置了自己喜欢的速度,但对跑步机的速度并不知情。在 30 秒的采集期内收集了空间(足旋转、步宽、步长和步长)、时间(步长和步时、站立、摆动和单支撑和双支撑时间、支撑时间)和峰值垂直地面反力变量,平均有 52±5 个稳定行走的步。在初始试验一周后和 20 分钟后再次重复测试。使用广义线性建模框架内的重复测量方差分析来评估步态参数在不同测试中的差异。使用 95%重复性系数评估同一日内(第 2 和第 3 次测试)和不同日之间(第 1 和第 2 次测试;第 1 和第 3 次测试)测量的步态参数之间的一致性。
在三个测试阶段,大多数(16 个中的 14 个)时间、空间和动力学步态参数存在统计学上的显著差异(P<0.01)。95%置信区间内,时间参数的最小可检测变化范围为 3%至 17%,空间参数的最小可检测变化范围为 14%至 33%,动力学参数的最小可检测变化范围为 4%至 20%。日内重复性与日间观察到的重复性相似。时间和动力学步态参数通常比空间参数更一致。跑步机系统垂直力峰值的 95%重复性系数在±53 至±63N 之间。
跑步机系统的空间参数和地面反力的一致性界限包含了以前报道的神经肌肉病理和鞋类干预的变化。这些发现为临床医生和研究人员提供了关于 Zebris 跑步机系统检测常见时空步态参数和垂直地面反力变化的重复性和敏感性的指示。