McAndrew Christopher M, Merriman David J, Gardner Michael J, Ricci William M
Department of Orthopaedic Surgery, Washington University in Saint Louis, St. Louis, MO.
J Orthop Trauma. 2014 Dec;28(12):665-73. doi: 10.1097/BOT.0000000000000127.
The null hypothesis of this study states that routine axial computed tomography (CT) images are obtained at a consistent and reproducible orientation relative to the sacrum. The secondary null hypothesis states that there is no difference in the measurement of the safe zone for placement of iliosacral screws when using routine axial CT images and standardized reconstructions in defined planes perpendicular and parallel to the sacrum.
Retrospective review.
University Level 1 Trauma Center.
Sixty-eight consecutive trauma patients evaluated with routine pelvic CT, without pelvic ring injury.
Retrospective radiographic review and measurement.
Sixty-eight consecutive adult patients with routine axial pelvic CT scans, without injury to the pelvic ring, and obtained as part of a trauma evaluation were retrospectively identified. The orientation of the axial slices relative to the sacrum was measured for each patient and compared. The maximal cross-sectional distance at the smallest section of the sacral ala (safe zone) was measured using the routine axial CT images, and these measurements were compared with similar measurements taken on standardized images perpendicular (CT inlet) and parallel (CT outlet) to the body of the sacrum. Additional data referencing the orientation of multiple sacral radiographic landmarks were also collected.
The orientation of routine axial CT image planes relative to the sacrum spanned a wide range. The angle between the routine axial CT plane and the sacrum varied from 43.5 to 82.0 degrees (SD = 9 degrees). Significant differences were found in measured safe zones of routine axial CT images compared with standardized CT inlet and CT outlet images. Compared with CT inlet images, routine axial CT images underestimated safe zones for transverse sacral screws at both S1 (P < 0.01) and S2 (P < 0.01). When compared with CT outlet images, routine axial CT images overestimated safe zones for oblique sacroiliac screws (P < 0.01) and underestimated the safe zone for S2 transverse sacral style screws (P < 0.01). No significant differences in measured variables were found between genders and sacral morphology.
Our null hypotheses were rejected: routine axial CT images were found to be at widely ranging orientations relative to the sacrum, and standardized CT images (CT inlet and CT outlet) demonstrated statistically significant differences in measurements of safe zones compared with routine axial CT images. Furthermore, the CT inlet and CT outlet views provide additional information regarding sacral landmarks that could be useful for preoperative planning.
本研究的原假设指出,常规轴向计算机断层扫描(CT)图像是相对于骶骨以一致且可重复的方向获取的。次要原假设指出,在使用常规轴向CT图像和在与骶骨垂直和平行的特定平面上的标准化重建图像时,髂骶螺钉置入安全区的测量没有差异。
回顾性研究。
一级大学创伤中心。
连续68例接受常规骨盆CT检查且无骨盆环损伤的创伤患者。
回顾性影像学检查和测量。
回顾性确定68例连续的成年患者,这些患者接受了常规轴向骨盆CT扫描,无骨盆环损伤,且作为创伤评估的一部分进行检查。测量并比较每位患者轴向切片相对于骶骨的方向。使用常规轴向CT图像测量骶骨翼最小截面处的最大横截面距离(安全区),并将这些测量结果与在垂直于(CT入口)和平行于(CT出口)骶骨体的标准化图像上进行的类似测量结果进行比较。还收集了参考多个骶骨放射学标志方向的其他数据。
常规轴向CT图像平面相对于骶骨的方向范围很广。常规轴向CT平面与骶骨之间的角度在43.5度至82.0度之间变化(标准差=9度)。与标准化CT入口和CT出口图像相比,常规轴向CT图像测量的安全区存在显著差异。与CT入口图像相比,常规轴向CT图像在S1(P<0.01)和S2(P<0.01)水平均低估了横骶螺钉的安全区。与CT出口图像相比,常规轴向CT图像高估了斜骶髂螺钉的安全区(P<0.01),并低估了S2横骶型螺钉的安全区(P<0.01)。在性别和骶骨形态之间,测量变量未发现显著差异。
我们拒绝了原假设:发现常规轴向CT图像相对于骶骨的方向范围很广,并且标准化CT图像(CT入口和CT出口)与常规轴向CT图像相比,在安全区测量方面显示出统计学上的显著差异。此外,CT入口和CT出口视图提供了有关骶骨标志的额外信息,这可能对术前规划有用。