Suppr超能文献

全膝关节置换术中使用的局部抗菌溶液对缝合线拉伸强度的影响。

Effects of Topical Antiseptic Solutions Used During Total Knee Arthroplasty on Suture Tensile Strength.

作者信息

Newman Jared M, George Jaiben, Shepherd Jeffery T, Klika Alison K, Higuera Carlos A, Krebs Viktor E

机构信息

Department of Orthopaedic Surgery, Cleveland Clinic, Cleveland, Ohio.

>Department of Orthopaedic Surgery, Cleveland Clinic, Cleveland, Ohio.

出版信息

Surg Technol Int. 2017 Jul 25;30:399-404.

Abstract

INTRODUCTION

Irrigating a surgical wound with an antiseptic solution is commonly performed while suturing following a total knee arthroplasty (TKA) to help prevent wound complications. The purpose of this study was to: 1) evaluate the mean load to failure of different sutures, and 2) compare the mean load to failure of the sutures after soaking in four different antiseptic solutions.

MATERIALS AND METHODS

Load-to-failure tests were conducted on four sets of comparable sutures (eight sutures) from two different companies Ethicon Inc. (Somerville, New Jersey) and Covidien (Mansfield, Massachusetts). The four suture types included: 1) non-absorbable braided polyethylene, 2) absorbable braided glycolide or lactide polymer, 3) absorbable monofilament polydioxanone or polyglyconate, and 4) absorbable monofilament polyglecaprone or gylcomer. Sutures were tested for tensile strength at baseline (i.e., no solution; n=5 per suture), and were then soaked for five minutes in one of four different antiseptic solutions: 0.125% sodium hypochlorite, 4% chlorhexidine gluconate, 10% povidone-iodine, and a 1:1 ratio of 3% hydrogen peroxide and sterile water. Effects of the different solutions on individual sutures were assessed with analysis of variance, and pairwise comparison tests were performed with post-hoc Tukey tests.

RESULTS

For the controls, the mean failure loads for the type 1 sutures were 118.5 N and 120.3 N, for the type 2 sutures, 145.8 N and 155.4 N, the type 3 sutures, 103.8 N and 162.2 N, and the type 4 sutures, 86.9 N and 87.7 N. After being soaked in sodium hypochlorite, the mean failure load decreased for one of the type 2 sutures (mean difference, -12.8 N;p=0.003), while the other type 2 suture had a decreased failure load after soaking in povidone-iodine (mean difference, -10.3 N;p=0.041) and hydrogen peroxide (mean difference, -14.6 N;p=0.001). A type 1 suture had an increased load to failure after soaking in povidone-iodine (mean difference, 13.2 N;p<0.0001) and hydrogen peroxide (mean difference, 10.5 N;p<0.0001).

CONCLUSION

Certain sutures may have changes in their breaking point depending on what type of antiseptic solution is used for wound irrigation, but due to the small magnitude of change, this may not necessarily be clinically relevant.

摘要

引言

全膝关节置换术(TKA)后缝合时,常用抗菌溶液冲洗手术伤口以预防伤口并发症。本研究的目的是:1)评估不同缝线的平均断裂负荷;2)比较浸泡在四种不同抗菌溶液后缝线的平均断裂负荷。

材料与方法

对来自两家不同公司(新泽西州萨默维尔的Ethicon公司和马萨诸塞州曼斯菲尔德的Covidien公司)的四组可比缝线(每组八根)进行断裂负荷测试。四种缝线类型包括:1)不可吸收编织聚乙烯;2)可吸收编织乙交酯或丙交酯聚合物;3)可吸收单丝聚二氧杂环己酮或聚甘醇酸酯;4)可吸收单丝聚甘醇酸内酯或乙交酯共聚物。在基线(即无溶液;每种缝线n = 5)时测试缝线的拉伸强度,然后将其浸泡在四种不同抗菌溶液之一中五分钟:0.125%次氯酸钠、4%葡萄糖酸氯己定、10%聚维酮碘以及3%过氧化氢与无菌水1:1的混合液。用方差分析评估不同溶液对各缝线的影响,并用事后Tukey检验进行成对比较测试。

结果

对于对照组,1型缝线的平均断裂负荷分别为118.5 N和120.3 N,2型缝线为145.8 N和155.4 N,3型缝线为103.8 N和162.2 N,4型缝线为86.9 N和87.7 N。浸泡在次氯酸钠中后,一种2型缝线的平均断裂负荷降低(平均差值,-12.8 N;p = 0.003),而另一种2型缝线在浸泡在聚维酮碘(平均差值,-10.3 N;p = 0.041)和过氧化氢(平均差值,-14.6 N;p = 0.001)后断裂负荷降低。一种1型缝线在浸泡在聚维酮碘(平均差值,13.2 N;p < 0.0001)和过氧化氢(平均差值,10.5 N;p < 0.0001)后断裂负荷增加。

结论

根据用于伤口冲洗的抗菌溶液类型,某些缝线的断裂点可能会发生变化,但由于变化幅度较小,这在临床上不一定具有相关性。

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验