Shen Chaobo, Hai Zhou, Zhao Cong, Zhang Jiawei, Evans John L, Bozack Michael J, Suhling Jeffrey C
Center for Advanced Vehicle and Extreme Environment Electronics (CAVE3), Auburn University, Auburn, AL 36849, USA.
Materials (Basel). 2017 Apr 26;10(5):451. doi: 10.3390/ma10050451.
This study illustrates test results and comparative literature data on the influence of isothermal aging and thermal cycling associated with Sn-1.0Ag-0.5Cu (SAC105) and Sn-3.0Ag-0.5Cu (SAC305) ball grid array (BGA) solder joints finished with ENIG and ENEPIG on the board side and ENIG on the package side compared with ImAg plating on both sides. The resulting degradation data suggests that the main concern for 0.4 mm pitch 10 mm package size BGA is package side surface finish, not board side. That is, ENIG performs better than immersion Ag for applications involving long-term isothermal aging. SAC305, with a higher relative fraction of Ag₃Sn IMC within the solder, performs better than SAC105. SEM and polarized light microscope analysis show cracks propagated from the corners to the center or even to solder bulk, which eventually causes fatigue failure. Three factors are discussed: IMC, grain structure, and Ag₃Sn particle. The continuous growth of Cu-Sn intermetallic compounds (IMC) and grains increase the risk of failure, while Ag₃Sn particles seem helpful in blocking the crack propagation.
