Kuncová Gabriela, Ishizaki Takayuki, Solovyev Andrey, Trögl Josef, Ripp Steven
Institute of Chemical Process Fundamentals of the CAS, v.v.i., Rozvojová 135, 16500 Praha 6, Czech Republic.
Faculty of Environment, Jan Evangelista Purkyně University in Ústí nad Labem, Králova Výšina 3132/7, 40096 Ústí nad Labem, Czech Republic.
Materials (Basel). 2016 Jun 15;9(6):467. doi: 10.3390/ma9060467.
Living cells of the -based bioluminescent bioreporter TVA8 were encapsulated in a silica hydrogel attached to the distal wider end of a tapered quartz fiber. Bioluminescence of immobilized cells was induced with toluene at high (26.5 mg/L) and low (5.3 mg/L) concentrations. Initial bioluminescence maxima were achieved after >12 h. One week after immobilization, a biofilm-like layer of cells had formed on the surface of the silica gel. This resulted in shorter response times and more intensive bioluminescence maxima that appeared as rapidly as 2 h after toluene induction. Considerable second bioluminescence maxima were observed after inductions with 26.5 mg toluene/L. The second and third week after immobilization the biosensor repetitively and semiquantitatively detected toluene in buffered medium. Due to silica gel dissolution and biofilm detachment, the bioluminescent signal was decreasing 20-32 days after immobilization and completely extinguished after 32 days. The reproducible formation of a surface cell layer on the wider end of the tapered optical fiber can be translated to various whole cell bioluminescent biosensor devices and may serve as a platform for sensors.
基于荧光素酶的生物发光生物报告基因TVA8的活细胞被封装在附着于锥形石英纤维远端较宽一端的二氧化硅水凝胶中。用高浓度(26.5毫克/升)和低浓度(5.3毫克/升)的甲苯诱导固定化细胞的生物发光。在超过12小时后达到初始生物发光最大值。固定一周后,硅胶表面形成了一层类似生物膜的细胞层。这导致响应时间缩短,生物发光最大值更强,在甲苯诱导后2小时内迅速出现。在用26.5毫克甲苯/升诱导后观察到相当大的第二次生物发光最大值。固定后的第二周和第三周,生物传感器在缓冲介质中重复并半定量地检测到甲苯。由于硅胶溶解和生物膜脱落,生物发光信号在固定后20 - 32天逐渐减弱,并在32天后完全熄灭。在锥形光纤较宽一端可重复形成表面细胞层,这可转化应用于各种全细胞生物发光生物传感器装置,并可作为传感器的一个平台。