Zhang F, Denome R M, Cole C N
Mol Cell Biol. 1986 Dec;6(12):4611-23. doi: 10.1128/mcb.6.12.4611-4623.1986.
Most eucaryotic mRNAs are polyadenylated. In higher eucaryotes, the sequence AATAAA is located 7 to 30 base pairs (bp) upstream from the site of processing and polyadenylation and is a critical part of the signal for processing and polyadenylation. Efficient cleavage and polyadenylation also require sequences downstream of polyadenylation sites. The herpes simplex virus type 1 thymidine kinase (tk) gene contains two copies of the AATAAA hexanucleotide and a GT box (18 of 19 consecutive residues are G or T) previously shown to be required for efficient processing and polyadenylation of tk mRNA (C. N. Cole and T. P. Stacy, Mol. Cell. Biol., 5:2104-2113). To define further the sequence requirements for efficient polyadenylation, we prepared linker scanning, internal deletion, and small insertion mutations in the polyadenylation region of the tk gene. These mutations were analyzed by S1 nuclease protection analysis of cytoplasmic RNA isolated from transfected Cos-1 monkey kidney cells. When the proximal AATAAA was deleted, no tk mRNA polyadenylated in the normal region was detected, whereas replacement of the second AATAAA with an XbaI linker had no effect on polyadenylation. When various portions of the GT box were replaced with linker, the amount of tk mRNA produced was reduced to 23 to 82% of the normal amount, but polyadenylation in the normal region was never abolished. Thus, no single portion of the GT box was absolutely required. In some cases, extended transcripts, polyadenylated at a cryptic site within pBR322, were detected. A spacing of 6 bp between AATAAA and the GT box was too short for efficient processing and polyadenylation. A spacing of 30 bp appeared to work almost as efficiently as did the wild-type spacing of 18 bp. Taken together, these results indicate that efficient polyadenylation requires both AATAAA and downstream GT-rich sequences. In addition, processing and polyadenylation are affected both qualitatively and quantitatively by sequences at polyadenylation sites and at more distant locations.
大多数真核生物的信使核糖核酸(mRNA)都进行了多聚腺苷酸化。在高等真核生物中,序列AATAAA位于加工和多聚腺苷酸化位点上游7至30个碱基对(bp)处,是加工和多聚腺苷酸化信号的关键部分。有效的切割和多聚腺苷酸化还需要多聚腺苷酸化位点下游的序列。单纯疱疹病毒1型胸苷激酶(tk)基因包含两个AATAAA六核苷酸拷贝和一个GT框(19个连续残基中有18个是G或T),先前已证明tk mRNA的有效加工和多聚腺苷酸化需要该GT框(C.N.科尔和T.P.斯泰西,《分子细胞生物学》,5:2104 - 2113)。为了进一步确定有效多聚腺苷酸化的序列要求,我们在tk基因的多聚腺苷酸化区域制备了接头扫描、内部缺失和小插入突变。通过对从转染的Cos - 1猴肾细胞中分离的细胞质RNA进行S1核酸酶保护分析来分析这些突变。当近端的AATAAA被删除时,在正常区域未检测到多聚腺苷酸化的tk mRNA,而用XbaI接头替换第二个AATAAA对多聚腺苷酸化没有影响。当GT框的不同部分被接头替换时,产生的tk mRNA量减少到正常量的23%至82%,但正常区域的多聚腺苷酸化从未被消除。因此,GT框的任何单个部分都不是绝对必需的。在某些情况下,检测到在pBR322内一个隐蔽位点进行多聚腺苷酸化的延伸转录本。AATAAA与GT框之间6 bp的间距对于有效加工和多聚腺苷酸化来说太短。30 bp的间距似乎几乎与18 bp的野生型间距一样有效。综上所述,这些结果表明有效多聚腺苷酸化需要AATAAA和下游富含GT的序列。此外,加工和多聚腺苷酸化在质量和数量上都受到多聚腺苷酸化位点及更远处序列的影响。