Nucleotide binding sites and chemical modification of the chromaffin granule proton ATPase.

The purified proton ATPase of chromaffin granules contains five different polypeptides denoted as subunits I to V in the order of decreasing molecular weights of 115,000, 72,000, 57,000, 39,000, and 17,000, respectively. The purified enzyme was reconstituted as a highly active proton pump, and the binding of N-ethylmaleimide and nucleotides to individual subunits was studied. N-Ethylmaleimide binds to subunits I, II, and IV, but inhibition of both ATPase and proton pumping activity correlated with binding to subunit II. In the presence of ADP, the saturation curve of ATP changed from hyperbolic to a sigmoid shape, suggesting that the proton ATPase is an allosteric enzyme. Upon illumination of the purified enzyme in the presence of micromolar concentrations of 8-azido-ATP, alpha-[35S]ATP, or alpha-[32P]ATP subunits I, II, and IV were labeled. However, at concentrations of alpha-[32P]ATP below 0.1 microM, subunit II was exclusively labeled in both the purified and reconstituted enzyme. This labeling was absolutely dependent on the presence of divalent cations, like Mg2+ and Mn2+, while Ca2+, Co2+, and Zn2+ had little or no effect. About 0.2 mM Mg2+ was required to saturate the reaction even in the presence of 50 nM alpha-[32P]ATP, suggesting a specific and separate Mg2+ binding site on the enzyme. Nitrate, sulfate, and thiocyanate at 100 mM or N-ethylmaleimide and 7-chloro-4-nitrobenzo-2-oxa-1,3-diazole at 100 microM prevented the binding of the nucleotide to subunit II. The labeling of this subunit was effectively prevented by micromolar concentrations of three phosphonucleotides including those that cannot serve as substrate for the enzyme. It is concluded that a tightly bound ADP on subunit II is necessary for the activity of the enzyme.